Congratulations, you are now the proud owner of an ARTUSI cooking appliance. Thank you for purchasing ARTUSI
and welcome to the ARTUSI Family.
This instruction manual has been specially created to inform you of the full range of features your ARTUSI appliance
has to offer and serves as an introduction to getting the very best out of your ARTUSI appliance.
We present detailed information on each of the features your ARTUSI appliance consists of. Once you have read
this section you will be able to choose the most appropriate settings for your appliance when cooking different
types of food.
We ask you to read the instructions in this booklet very carefully as this will allow you to get the best results from
using your appliance. KEEP THE DOCUMENTATION OF THIS PRODUCT FOR FUTURE REFERENCE.
TO REGISTER YOUR PRODUCT WITH ARTUSI, PLEASE FILL OUT THE WARRANTY CARD AT THE END OF
THIS BOOKLET AND POST IT TO: REPLY PAID 83617
LEICHHARDT NSW 2040
Dear Artusi Customer, please read this user manual carefully before using the product and, keep it permanently at
your disposal.
Note: This user manual is prepared for more than one model. Some of the features specified in this Manual may not
be available on your appliance.
All our appliances are only for domestic use, not for commercial use. Products marked with (*) are optional.
“THIS APPLIANCE SHALL BE INSTALLED IN ACCORDANCE WITH THE REGULA TIONS FORCE AND ONLY USED
IN A WELL VENTILATED SPACE. READ THE INSTRUCTIONS BEFORE INSTALLING OR USING THIS APPLIANCE”
“Conforms with the WEEE Regulations.”
BUILT-IN GAS HOB
INSTALLATION AND USER INSTRUCTIONS
CAGH1
CAGH95X
CAGH75X
CAGH600CIX
CAGH600X
Note: Do not use the hob until you have read the instruction manual.
Cod:0070302047
1. INTRODUCTION
Semirapid
gas burner
6.3 MJ/h
Triple flame
gas burner
13.7 MJ/h
CAGH1
CAGH600CIX
CAGH600X
Triple flame gas burner 13.7 MJ/h
Semirapid
gas burner
6.3 MJ/h
Semirapid
gas burner
6.3 MJ/h
Even if you have used a gas hob before, it is important that you read these instructions thoroughly
before using the appliance, paying particular attention to the installation and safety instructions. If you
have any problems installing, operating or cooking with your hob, please check through these
instructions to ensure all of them have been adhered to.
WARNING! For your own safety, make sure that these instructions on installation, use and
maintenance are followed.
Please keep these instructions in a safe place for future reference.
Should the appliance be sold or transferred, please pass on these instructions to the new owner.
CAGH75X
Semirapid
gas burner
6.3 MJ/h
Auxiliary
gas burner
3.6 MJ/h
Rapid
gas burner
10.8 MJ/h
Auxiliary
gas burner
3.6 MJ/h
Applicable for Gas
Semi-rapid
Triple flame
Type
gas burner
CAGH1
CAGH600CIX
13.7 MJ/h 6.3 MJ/h 3.6 MJ/h 477x557
CAGH600X
13.7 MJ/h 10.8 MJ/h 6.3 MJ/h 3.6 MJ/h
CAGH95X
13.7 MJ/h 10.8 MJ/h 6.3 MJ/h 3.6 MJ/h
CAGH75X
The surface of the hob need to be cleaned after each time they used.
Dayly cleaning
VITREOUS ENAMEL
Hotplate, burner caps, pan supports.
Cloth wrung out in hot soapy water. Stubborn stains.can be removed with a cream paste.
approved by the Vitreous Enamel Development Council, liquid cleaner or by rubbing with fine steel
wool soap pads.
NOTE: The pan supports can also be cleaned in the dishwasher.
ALUMINIUM
Hotplate burner bodies.
Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from
the hotplate burner bodies. After cleaning, wipe dry and refit to the hob ensuring they are correctly
seated.
Check parts are reassembled correctly by lighting the burners and allowing to dry out.
PLASTIC
Control knobs.
Wipe with a cloth wrung out in hot soapy water.
STAINLESS STEEL
Cloth wrung out in hot soapy water.
Rapid
gas
gas
burner
burner
/ Yes
3. CLEANING AND MAINTENANCE
Rapid
gas burner
10.8 MJ/h
Triple flame
gas burner
13.7 MJ/h
Auxiliary
gas burner
3.6 MJ/h
2. YOUR HOB
Auxiliary
gas
Material
burner
Stainless
steel
Stainless
steel
Stainless
steel
CAGH95X
Flame
failure
device
Yes
Yes
Power
Supply
AC
220-240 V
50-60Hz
Semirapid
gas burner
6.3 MJ/h
Semirapid
gas burner
6.3 MJ/h
Size
(mm)
500x580x90
500x860x90
500x680x90
Built-in
(mm)
477x837
477x557
1
WARNINGS
Comply with the following instructions, before remounting the parts:
-Check that the heads burners and the relative burner caps, are correctly positioned in their
housings.
-Check that burner head slots have not become clogged by foreign bodies.
-If to happened installation or after a few fimes, you find a tap is difficult to open or close do
not force it but call for techniacl assistance urgently.
-After use, to keep them in good condition, the plates should be treated with specific
products, easily found in the shops, to keep the surfaces clean and shining. This will also
prevent rust from forming.
-If any liquid spills over it must always be removed with a sponge.
4. SAFETY INSTRUCTIONS
Make sure that this instruction booklet is read thoroughly and understood before attempting to install or
operate this hob.
The instructions are provided in the interest of your safety.
GAS SAFETY REGULATIONS AND USE OF YOUR HOB
1. It is a legal requirement that all gas appliances are installed by qualified personnel only in accordance
with current legislation. It is your responsibility to ensure compliance with the law.
2. Repairs or servicing of this product must only be carried out by an authorised service agent using
approved parts.
3. No attempt must be made to modify this appliance under any circumstances.
4. Cooking appliances can become very hot in use – please keep children and pets away from them.
5. Do not allow children to operate or play with any part of the appliance.
6. Do not use unstable pans and ensure that the handle is positioned away from the edge of the worktop.
7. In the interest of hygiene and safety, please ensure the hob is kept clean.
8. This appliance is designed for domestic cooking only. Commercial use will invalidate the warranty.
9. Do not cover the hob or place combustible materials on or near the surface even when the hob is not in
use.
10. Do not fill deep fat frying containers more than one third full of oil and NEVER leave unattended.
11. Before cleaning the hob, switch off at the mains.
12. When cooking is finished, switch off all controls and allow to cool.
13. These appliances are not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
14. If the supply cable is damaged, it must be replaced by the authorised service agent or qualified person only.
15. Do not immerse the appliance or the power cable into water or any other liquid.
16. DO NOT SPRAY AEROSOLS IN THE VICINTY OF THIS APPLIANCE WHILE IT IS IN OPERATION.
17. DO NOT USE OR STORE FLAMMABLE MATERIALS ON OR NEAR THIS APPLIANCE.
18. DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
19. DO NOT MODIFY THIS APPLIANCE.
TECHNICAL INFORMATION
The installation, adjustments, conversions and maintenance listed in this section must be carried out by
qualified personnel only.
The safety and automatic adjustment devices of the appliance may only be modified by an authorised service
agent.
The installation of this gas hob must comply with Australia and New Zealand standards.
This appliance must be fitted in compliance with the installation rules given above. Also, particular attention
5. INSTALLATION INSTRUCTIONS
VENTILATION RECOMMENDATION
The room must have an opening window or equivalent, some rooms may also require a permanent
vent. If the room has a volume between 5-10m
unless it has a door which opens directly to the outside. If the room has a volume of less than 5m
will require an air vent of 100cm
When using more than one hotplate at once, open a window if a mechanical extractor is not present or
working (Fig. 3).
2
effective area (Fig. 1).
(*) Air inlet minimum section: 100cm
3
, it will require an air vent of 50cm2 effective area,
2
3
, it
UNPACKING THE APPLIANCE
Remove all packaging and make sure the appliance is in perfect condition.
If you have any doubts, do not use the appliance and call your supplier..
Some parts on the appliance are protected by a plastic film. This protective film must be removed
before the appliance is used.
The packaging materials should be carefully discarded and not left within easy reach of children as they
are a potential hazard.
INSTALLING AND FIXING THE HOB (QUALIFIED PERSONNEL ONLY)
The appliance can be fitted to any worktop with a thickness of 40mm or 50mm.
No overhanging surface or cooker hood should be closer to the hob than 750mm.
Fix the appliance in position (Fig. 4). The sides of the adjacent cabinets above may be lower than
750mm down to 650mm, provided they are heat and steam resistant.
These hobs are supplied with a special seal which prevents liquids from seeping underneath the
appliance. Follow these instructions in order to correctly fit this seal:
Detach the seals from their backing ensuring that the transparent protection still adheres to the seal.
Turn the hob over and correctly position seal *E* (Fig. 5) under the edge of the hob so that the outer
part of the seal perfectly matches the outer edge of the hob. The ends of the strips must fit together
without overlapping. Fix the seal to the hob evenly and securely, pressing it firmly in place.
Fig. 1 Fig. 2 Fig. 3
Unit: mm
477
557
CAGH1 CAGH95X
CAGH75X
CAGH600CIX
CAGH600X
90
Fig. 4
477
90
837
650-750
E
E
Fig. 5
2
3