You can find herewith some generic information to simplify cunsulting of technical documentation:
1. Models of same range share the same exploded views, which report the richest set of spare parts:generally, a model does not necessarly have a
related spare part for each particular shown on exploded views.
2. Some spare parts can not be represented directly on the exploded views (instruction booklets, specific kit, etc...). You can find those codes in the
spare parts list with the same reference of particular where spares are installed or with references 099, 999. Instruction booklets, once managed,
appear with 000 reference.
3. On the higher right site of each exploded view there is a serial number which indicates the beginning of the production of certain range:some
models might have more than an exploded view for a given category, each distinguished by a different serial no.and linked to another spare parts
list, In this case, serial no. is required to supply the right spare part code. Exploded view to be considered is the one with a more recent serial no.
but previous than the one of the model that needs assistance.
4.Exploded views might require further updates even after publishing. Addition of new spares will go on following the already existing numeration
references. Revision number of an exploded view is shown into last four digits of serial number into upper right hand corner.
5.The spare parts list associated to an exploded view shows related codes of spares managed for a certain model; for each spare part other
informations are available:
REF: reference no of spare into a table; SUBSTITUTE: list of spare(s) which can replace a code but that keeps same functional characteristics
INDUSTRIAL CODE: list of variables of a model (shown into model label) where such spare is used; NOTICE: code of information(s) to refer to
complete technical intervention, track for changes or to find correct spare part code.
6. Some notices, into a same section are generic therefore cannot be directly linked to a spare part. In order to assist a model in the best way as
possible, it is helpful to pay attention to all notices and constantly verify documentation updates
7.Technical documentation cover shows model name and its commercial codes
From serial no. 40825.0001, the vent tube has been modified with the elimination of the vent from the rear panel of all top-load washing machines
affected by this note (see photo N1040336FIG1).
Given below are the codes of the modified items:
- Vent tube: premodification 085471 new 112602;
- Rear panel: premodification 098566 new 112632;
- Vent grid code 083944 has been eliminated.
n1040336
Elimination of vent from rear panel of top-load washing machines.
From serial no. 40825.0001, the vent tube has been modified with the elimination of the vent from the rear panel of all top-load washing machines
affected by this note (see photo N1040336FIG1).
Given below are the codes of the modified items:
- Vent tube: premodification 085471 new 112602;
- Rear panel: premodification 098566 new 112632;
- Vent grid code 083944 has been eliminated.
page 15
page 16
Electric schemes and links
Cod. 16001744300
page 17
Legend
Legend: 16001744300
AQSAquastop electrovalveMzbn/MTAzbn timer motor
BBuzzerNNeutral or Terminal Board
BCNCSpin cycle exclusion
BFTerminal board contact, motor fan and dryer
BPBuzzerPAHigh speed potentiometer
CCondensatorPBLow speed potentiometer
CACondensatorPLPure Wool
DVSwitching devicePMMotor Thermoprotector
EF/CLElectro-Valve Cold Water / BleachPRTimer programmer or Pressure switch
EF/LElectro-Valve Cold Water / WashPSDrain pump
EF/PElectro-Valve Cold Water / PrewashP11st level pressure cut-off switch