Operating and Cleaning Instructions
How to use:
• Always place this unit on a firm, flat and level surface.
The humidifier may not work properly on uneven surfaces.
Filling the tank:
1. Remove tank from base by grasping handle and pulling upward
2. Turn water tank upside-down and unscrew the fill cap by turning it counter clockwise
3. Fill tank with cool, distilled or tap water.
• Distilled or softened water preferred. Minerals in tap water may cause a white dust to appear around unit and
on your furniture.
• Water temperature should not be to hot or to cold. Extreme temperatures damage unit.
4. Replace the fill cap by turning it clockwise. (Do not over tighten)
5. Return tank to base and let water settle for a few minutes.
Power:
1. Plug power cord into a 120V AC wall outlet only.
2. Set rotate switch to desired position.
• Ion=Negative ions will be emitted which can eliminate dust particles in the air
• Ion & Moisture=Rapidly adds moisture to the air while Ions eliminate dust particles for a clean, fresher air.
3. Aim nozzle away from the furniture and walls for proper air flow
4. Turn rotate switch to off when finished. Will operate approximately 12-14 hours in continuous use.
• Add water indicator light will illuminate when tank is empty but motor will still run.
• Do not leave water in tank for prolonged period. This can encourage bacteria growth.
How to Clean:
• We recommend cleaning the humidifier weekly during use, or more often if you have hard water, before storing
or after unit has been stored for a long time. Use a mild bleach and water solution, never use detergent.
1. Remove tank from base by grasping handle and pulling upward
2. Turn water tank upside-down and unscrew the fill cap by turning it counter clockwise
3.. Empty reservoir
4. Fill water tank with 1 teaspoon of household bleach and water. Let stand for 20 minutes.
5. Use a brush to clean off mineral deposits and debris from nebulizer and water sensor
• Do not scrape or clean with metal tools
6. Empty reservoir and rinse with water until bleach odor is gone.
7. Make sure all parts are thoroughly dry before storing.