Page 1
1995-2002
Land Rover/ Range Rover
New Coil Spring Conversion Kit.
Installation Guide
Arnott part # RR-CONV
Copyright © 2005 Arnott Inc. All Rights Reserved.
Page 2
Front Air Spring Removal:
1. Raise the front suspension of the vehicle with proper lifting equipment. Both wheels must be off the ground
with no load. ALWAYS USE EXTREME CAUTION WHEN LIFTING VEHICLE! (Refer to shop
manual for lifting instructions)
2. Remove both front wheels.
air hose. To remove air hose, push down on the
metal collet, while pulling out on the hose.
3. Remove plastic wheel arch liner. 4. Depressurize air spring by removing nylon
5. Remove the two upper securing clips. 6. Remove the bolt securing the lower air
spring retaining pin to the front axle.
1
Page 3
7. Remove lower air spring retaining pin. 8. Remove and discard old air spring.
Front coil spring installation.
11. Install front coil spring onto the suspension. the front coil springs so you can replace lower shock
Hold the coil spring against the upper mount, nuts. (Reverse step #9) REPLACE FRONT WHEELS
while sliding lower spring perch into place.
9. Remove retaining nut from both front shocks. 10. Install upper coil spring rubber isolator.
12. Using a floor jack, jack up the axle, compressing
2
Page 4
Rear Air Spring Removal:
1. Raise the rear suspension of the vehicle with proper lifting equipment. Both wheels must be off the ground
with no load. ALWAYS USE EXTREME CAUTION WHEN LIFTING VEHICLE! (Refer to shop
manual for lifting instructions)
2. Remove both rear wheels.
air hose. To remove air hose, push down on the
metal collet, while pulling out on the hose.
3. Depressurize air spring by removing nylon 4. Remove top air spring clip.
5. Remove lower air spring securing clip. 6. Remove and discard old air spring.
3
Page 5
Rear coil spring installation.
7. Remove retaining nuts from both rear shocks. 8. Install coil spring onto rear suspension.
Align the upper aluminum spring mount in place.
9. Hold the coil spring against the upper mount,
while sliding lower spring perch into place.
10. Using a floor jack, jack up the axle, compressing coil springs so you can replace lower shock
retaining nuts
11. Replace wheels and lower vehicle.
4
Loading...