Page 1
REAR -- AIR SPRING ASSEMBLY
WARNING: Always support the vehicle on safety
Removal
4
WARNING: The air suspension system is under pressure (up to 10 bar, or
150 lbf/in²). Do not allow dirt or grease to enter the system. Always wear standard protective hand,
ear, and eye protection when servicing the air suspension system.
WARNING: Do not inflate the air spring assembly unless it is supported on
both ends by the vehicle frame and suspension system. An unrestricted or
unsupported air spring could cause serious injury and damage to the air
spring assembly. DO NOT DISASSEMBLE THE AIR SPRING!
1. Raise the vehicle on a hoist or other adequate structure.
stands. Refer to your vehicle’s Owner’s Manual for correct lifting instructions.
2. Remove the rear wheel arch liner.
3. Support the chassis from under the rear cross member. Depressurize the air suspension system.
4. With pliers, or a suitable hooked tool, remove the clip that secures the top of the air spring to the chassis.
NOTE: To access the clip, go under the wheel arch, between the body of the vehicle and the chassis.
5. After removing the clip, affix the bottom of the air spring to axle.
6. Raise chassis for extra clearance for removing the old spring. Re-support the chassis.
7. Remove the air spring from chassis. Clean connections and disconnect the air hose.
8. Seal off hose to prevent dirt or grease from entering system.
7
CAUTION: When refitting the new air spring, do not allow the vehicle to
rest on the deflated air spring. The chassis must be supported until the new
air spring is inflated.
Refitting
9. Refit new rear air spring; remove seal from air hose. Connect the hose to the air spring.
10. Affix the air spring to the chassis. Secure the top of the air spring to the chassis with the removed clip.
CAUTION: Ensure the air hose is routed correctly and that it is free of
kinks or bends.
11. Remove the support from the chassis and slowly lower air spring onto the axle. Re-support the chassis.
12. Fit the clip to secure bottom of the air spring to axle.
13. Remove all safety stands and lower vehicle.
14. Re-inflate system and perform a leak test on the air spring and connector with a soapy water solution.
WARNING: Make sure to tighten all wheel hub bolt nuts to 115-142 Nm (85105 lb/ft).
NAME
RLS
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
ARNOTT, INC. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
ARNOTT, INC. IS
PROHIBITED.
NEXT ASSY
APPLICATION
USED ON
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL
ANGULAR: MACH BEND
TWO PLACE DECIMAL
THREE PLACE DECIMAL
MATERIAL
FINISH
DO NOT SCALE DRAWING
DRAWN
CHECKED
ENG APPR.
MFG APPR.
Q.A.
COMMENTS:
DATE
05/30/06
RANGE ROVER
REAR AIR SPRING
SIZE
DWG. NO.
REAR ILLUSTRATION-A
A
SCALE:1:4
WEIGHT:
5
REV.
0
SHEET 1 OF 1
Loading...