ARNOTT P-2539 User Manual REV 5

Page 1
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
Congratulations on your purchase of an Arnott® air suspension product. We at Arnott Incorporated are proud to offer a high quality product at the industry’s most competitive pricing. Thank you for your condence in us
and our product.
Proper installation is essential to experience and appreciate the benets of this system. Please take a moment
to review these installation instructions before you begin to install these components on your vehicle. The
removal and installation of air suspension products should only be performed by a fully qualied, ASE
Certied, professional.
It is equally important to be aware of all necessary safety measures while installing your new Air Suspension
System. This includes proper lifting and immobilizing of the vehicle and isolation of any stored energy to
prevent personal injury or property damage.
"Engineered to Ride, Built to Last™"
WARNING:
and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system. Always wear standard hand, ear, and eye protection when servicing the air suspension system.
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved
KIT CONTAINS:
PARTS LIST
P/N QTY DESCRIPTION
21-6293 1 WABCO OES AIR SUSPENSION COMPRESSOR
21-6586 1 ACCESSORY KIT
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email techassistance@arnottinc.com
1
REV 5 11/12/2013P-2539
Page 2
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
GENERAL INFORMATION:
Reading this manual signies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement, the full text of which is available at www.arnottinc.com.
• Not to be stored below 5oF (-15oC) and above 122oF (50oC).
• Avoid damage to air lines and cables.
• Removal and installation is only to be performed by fully qualied personnel.
• Use car manufacturer’s diagnostic software.
CAUTION:
in the instructions or in a different sequence.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specied
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath the vehicle if it is not adequately supported, as serious injuries and death can occur.
AIR SUSPENSION COMPRESSOR REMOVAL
NOTE:
THE COMPRESSOR IS LOCATED ON THE VEHICLES DRIVERS SIDE BEHIND THE FRONT BUMPER. (FIGURE A)
FIGURE A
2
REV 5 11/12/2013P-2539
Page 3
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
1. SET STEERING TO STRAIGHT AHEAD.
2. RAISE VEHICLE.
3. REMOVE FRONT LEFT WHEEL. (FIGURE B AND FIGURE C)
FIGURE B
FIGURE C
4. LOCATE AND REMOVE THE SCREWS FROM THE INNER FENDER WELL. (FIGURE D)
FIGURE D
3
REV 5 11/12/2013P-2539
Page 4
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
5. REMOVE INNER FENDER WELL FROM VEHICLE. (FIGURE E)
FIGURE E
6. LOOSEN AND REMOVE SKID PLATE FASTENERS AND REMOVE THE SKID PLATE TO EXPOSE VEHICLE'S AIR SUSPENSION COMPRESSOR. (FIGURE F)
FIGURE F
7. LOCATE AND DISCONNECT ALL THREE ELECTRICAL PLUGS FROM THE COMPRESSOR. (FIGURE G)
FIGURE G
4
REV 5 11/12/2013P-2539
Page 5
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
8. LOCATE AND REMOVE THE AIR LINE. REMOVE THE AIR LINE FITTING FROM THE AIR HOSE AND DISCARD. (FIGURE H)
FIGURE H
9. LOCATE THE INTAKE TUBE. SLIDE THE SPRING CLAMP DOWN THE HOSE AND DISCONNECT FROM THE COMPRESSOR. (FIGURE I)
FIGURE I
10. LOCATE AND REMOVE THE THREE MOUNTING NUTS ALONG WITH THE MOUNTING HARDWARE. (FIGURE J, FIGURE K, FIGURE L)
FIGURE J
5
REV 5 11/12/2013P-2539
Page 6
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
FIGURE K
FIGURE L
AIR SUSPENSION COMPRESSOR INSTALLATION
Tighten all nuts and bolts to manufacturer's specications during the installation process.
Do not remove the air tting from the air suspension compressor. Doing so may cause damage and/or void warranty. Remove the white shipping pin from the new air tting and insert the air line until fully seated.
1. INSTALLATION IS IN REVERSE ORDER OF AIR SUSPENSION COMPRESSOR REMOVAL.
6
REV 5 11/12/2013P-2539
Page 7
P-2539
WABCO OES AIR SUSPENSION COMPRESSOR
FOR 2002-2009
AUDI A8
WARNING
CRACKED AIR SPRINGS MUST BE CHANGED
TO VALIDATE THE WARRANTY ON THE COMPRESSOR
PLEASE READ ADDITIONAL WARRANTY INFORMATION ON THE BACK OF YOUR INVOICE
PROPER PROCEDURE FOR ASSESSING YOUR AIR SPRINGS CONDITION:
1. TURN OFF AIR SUSPENSION SWITCH IF EQUIPPED.
2. REFER TO OWNER’S MANUAL FOR PROPER LIFTING TECHNIQUES AND JACKING POINTS.
3. RAISE THE VEHICLE.
4. INSPECT AIR SPRINGS FOR ANY TYPE OF CRACKS OR EXCESSIVE WEAR. CRACKS IN AIR
SPRINGS ARE EVIDENT IF THEY ARE LEAKING. THIS WILL CAUSE THE COMPRESSOR TO
OVERHEAT FROM CONTINUOUS OPERATION.
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product, please contact Arnott by calling 800-251-8993 during normal business hours or email techassistance@arnottinc.com
7
REV 5 11/12/2013P-2539
Loading...