ARNOTT P-2136 User Manual REV 4

P-2136

WABCO OES AIR SUSPENSION COMPRESSOR

FOR 2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

(113" WHEELBASE MODELS)

Congratulations on your purchase of an Arnott® air suspension product. We at Arnott Incorporated are proud
to offer a high quality product at the industry’s most competitive pricing. Thank you for your condence in us

and our product.

Proper installation is essential to experience and appreciate the benets of this system. Please take a moment

to review these installation instructions before you begin to install these components on your vehicle. The

removal and installation of air suspension products should only be performed by a fully qualied, ASE

Certied, professional.

It is equally important to be aware of all necessary safety measures while installing your new Air Suspension

System. This includes proper lifting and immobilizing of the vehicle and isolation of any stored energy to

prevent personal injury or property damage.

"Engineered to Ride, Built to Last™"

WARNING:

and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system.
Always wear standard hand, ear, and eye protection when servicing the air suspension system.

The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved

KIT CONTAINS:

PARTS LIST

P/N QTY DESCRIPTION

21-6990 1 WABCO OES AIR SUSPENSION COMPRESSOR

21-6991 1 ACCESSORY KIT

Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product,
please contact Arnott by calling 800-251-8993 during normal business hours or email [e-mail]

1 P-2136

REV 4 05/19/2014

P-2136

WABCO OES AIR SUSPENSION COMPRESSOR

FOR 2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

(113" WHEELBASE MODELS)

GENERAL INFORMATION:

Reading this manual signies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.

• Not to be stored below 5oF (-15oC) and above 122oF (50oC).

• Avoid damage to air lines and cables.

• Removal and installation is only to be performed by fully qualied personnel.

• Use car manufacturer’s diagnostic software.

CAUTION:

in the instructions or in a different sequence.

Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specied

To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.

Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.

AIR SUSPENSION COMPRESSOR REMOVAL

1. SET STEERING TO STRAIGHT AHEAD.

2. LIFT VEHICLE AND REMOVE REAR RIGHT WHEEL TO LOCATE THE AIR SUSPENSION COMPRESSOR.

3. REMOVE THE TWO (2) BOLTS HOLDING THE BRACKET TO THE FRAME. (FIGURE 1)

2 P-2136

FIGURE 1

REV 4 05/19/2014

P-2136

WABCO OES AIR SUSPENSION COMPRESSOR

FOR 2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

(113" WHEELBASE MODELS)

4. LIFT THE COMPRESSOR UP TO DISENGAGE THE BRACKET FROM THE FRAME. (FIGURE 2)

FIGURE 2

5. WITH THE COMPRESSOR LOOSE YOU CAN NOW REMOVE THE TWO (2) AIR LINES CONNECTING TO
THE AIR SPRINGS. REMOVE AIR LINE FITTINGS FROM THE AIR HOSES AND DISCARD. (FIGURE 3)

FIGURE 3

6. WITH THE AIR SPRING LINES REMOVED ROTATE THE PUMP DOWN TO ACCESS THE WIRING HARNESSES,
BREATHER HOSE AND ACCESSORY HOSE. DISCONNECT ALL FOUR (4) AND REMOVE THE COMPRESSOR.
REMOVE THE AIR LINE FITTING FROM THE ACCESSORY HOSE AND DISCARD. (FIGURE 4)

FIGURE 4

3 P-2136

REV 4 05/19/2014

P-2136

WABCO OES AIR SUSPENSION COMPRESSOR

FOR 2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

(113" WHEELBASE MODELS)

7. REMOVAL COMPLETE.

AIR SUSPENSION COMPRESSOR INSTALLATION

Tighten all nuts and bolts to manufacturer's specications during the installation process.

Do not remove air ttings from the air suspension compressor. Doing so may cause damage and/or void warranty.
Remove white shipping pins from new air ttings and insert air lines until fully seated.

1. INSTALLATION IS IN THE REVERSE ORDER OF AIR COMPRESSOR REMOVAL.

4 P-2136

REV 4 05/19/2014

P-2136

WABCO OES AIR SUSPENSION COMPRESSOR

FOR 2002-2009

BRAVADA/ENVOY/RAINIER/TRAILBLAZER/SAAB 9-7

(113" WHEELBASE MODELS)

WARNING

CRACKED AIR SPRINGS MUST BE CHANGED

TO VALIDATE THE WARRANTY ON THE COMPRESSOR

PLEASE READ ADDITIONAL WARRANTY INFORMATION ON THE BACK OF YOUR INVOICE

PROPER PROCEDURE FOR ASSESSING YOUR AIR SPRINGS CONDITION:

1. TURN OFF AIR SUSPENSION SWITCH IF EQUIPPED.

2. REFER TO OWNER’S MANUAL FOR PROPER LIFTING TECHNIQUES AND JACKING POINTS.

3. RAISE THE VEHICLE.

4. INSPECT AIR SPRINGS FOR ANY TYPE OF CRACKS OR EXCESSIVE WEAR. CRACKS IN AIR

SPRINGS ARE EVIDENT IF THEY ARE LEAKING. THIS WILL CAUSE THE COMPRESSOR TO

OVERHEAT FROM CONTINUOUS OPERATION.

Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product,
please contact Arnott by calling 800-251-8993 during normal business hours or email [e-mail]

5 P-2136

REV 4 05/19/2014