Congratulations on your purchase of an Arnott® air suspension product. We at Arnott Incorporated are proud
to offer a high quality product at the industry’s most competitive pricing. Thank you for your condence in us
and our product.
Proper installation is essential to experience and appreciate the benets of this system. Please take a moment
to review these installation instructions before you begin to install these components on your vehicle. The
removal and installation of air suspension products should only be performed by a fully qualied, ASE
Certied, professional.
It is equally important to be aware of all necessary safety measures while installing your new Air Suspension
System. This includes proper lifting and immobilizing of the vehicle and isolation of any stored energy to
prevent personal injury or property damage.
"Engineered to Ride, Built to Last™"
WARNING:
and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system.
Always wear standard hand, ear, and eye protection when servicing the air suspension system.
The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved
KIT CONTAINS:
PARTS LIST
P/NQTYDESCRIPTION
21-61571ARNOTT REMANUFACTURED FRONT LEFT AIR STRUT
21-69031ACCESSORY KIT
Arnott® is committed to the quality of its products. If you have a question or problem with any Arnott product,
please contact Arnott by calling 800-251-8993 during normal business hours or email techassistance@arnottinc.com
1AS-2561REV 7 04/10/2014
Page 2
AS-2561
ARNOTT REMANUFACTURED
FRONT LEFT AIR STRUT
FOR 2002-2009 AUDI A8 (NORMAL)
GENERAL INFORMATION:
Reading this manual signies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
•Not to be stored below 5oF (-15oC) and above 122oF (50oC).
•Avoid damage to air lines and cables.
•Removal and installation is only to be performed by fully qualied personnel.
•Use car manufacturer’s diagnostic software.
CAUTION:
in the instructions or in a different sequence.
Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specied
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
AIR STRUT REMOVAL
1. SET STEERING TO STRAIGHT AHEAD.
2. LIFT VEHICLE AND REMOVE WHEEL. (FIGURE 10-1)
FIGURE 10-1
2AS-2561REV 7 04/10/2014
Page 3
AS-2561
ARNOTT REMANUFACTURED
FRONT LEFT AIR STRUT
FOR 2002-2009 AUDI A8 (NORMAL)
3. REMOVE WIRE HARNESS FROM MOUNTING BRACKET. (FIGURE 10-2)
FIGURE 10-2
4. DISCONNECT ELECTRICAL PLUG. (FIGURE 10-3)
FIGURE 10-3
5. LOOSEN AND REMOVE AIR LINE. REMOVE THE AIR LINE FITTING FROM THE AIR HOSE AND DISCARD. (FIGURE 10-4)
FIGURE 10-4
3AS-2561REV 7 04/10/2014
Page 4
AS-2561
ARNOTT REMANUFACTURED
FRONT LEFT AIR STRUT
FOR 2002-2009 AUDI A8 (NORMAL)
6. LOOSEN AND REMOVE UPPER CONTROL ARM BOLT. REMOVE UPPER ARMS FROM SPINDLE
ASSEMBLY. (FIGURE 10-5)
FIGURE 10-5
7. LOOSEN AND REMOVE LOWER SHOCK ARM BOLTS. (FIGURE 10-6)
FIGURE 10-6
8. LOOSEN AND REMOVE ALL THREE TOP BOLTS. (FIGURE 10-7)
FIGURE 10-7
4AS-2561REV 7 04/10/2014
Page 5
AS-2561
ARNOTT REMANUFACTURED
FRONT LEFT AIR STRUT
FOR 2002-2009 AUDI A8 (NORMAL)
9. SLIDE SHOCK OVER CONTROL ARM. REMOVE SHOCK SLOWLY FROM MOUNT AREA. (FIGURE 10-8)
FIGURE 10-8
10. GUIDE WIRE THROUGH THE HOLE WHILE REMOVING SHOCK. (FIGURE 10-9)
FIGURE F
FIGURE 10-9
5AS-2561REV 7 04/10/2014
Page 6
AS-2561
ARNOTT REMANUFACTURED
FRONT LEFT AIR STRUT
FOR 2002-2009 AUDI A8 (NORMAL)
11. LOOSEN AND REMOVE 4 TOP MOUNTING BOLTS FROM SHOCK (FIGURE 10-10)
FIGURE 10-10
12. REMOVE TOP SECTION. (FIGURE 10-11)
FIGURE 10-11
13. REMOVAL COMPLETE.
AIR STRUT INSTALLATION
Tighten all nuts and bolts to manufacturer's specications during the installation process.
Do not remove the air tting from the air strut. Doing so may cause damage and/or void warranty. Remove the white
shipping pin from the new air tting and insert the air line until fully seated.
1. INSTALLATION IS IN THE REVERSE ORDER OF AIR STRUT REMOVAL.
6AS-2561REV 7 04/10/2014
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.