Arkon TTGO115 User Manual

TTGO115 | Travelmount® Windshield or Dash Mount for TomTom® GO™ Series

Package Contents:

(1) CM014-2 - Mini windshield suction or dash mount (1) APTTGO520 - Adapter plate for TomTom GO™ Series

Patented

(1) AP036 - Adhesive circular disc (1) Alcohol cleaning pad

CM014-2 Mini Windshield or Dash Mount

AP036 Adhesive Disc

Windshield Mount Installation

Step 1.

Find a safe location on the interior of the vehicle’s windshield to mount the pedestal. Firmly push the suction base (A) against the windshield and  ip the base lever down (B) to the locked position. See diagram below.

Step 2.

Adjust the angle of the pedestal arm by tightening the angle adjustment knob (C) at the base to the desired angle.

APTTGO520 Adapter plate for TomTom GO x20, x30

Check Comp atibilit y

Patent Pending

TomTo m Device Com patib ility:

• TomTom GO 520 / 530 / 720 / 730 / 920 / 920T / 930

TomTom brand name and GO product name are trademarks, or registered trademarks of TomTom International NV. Arkon Resources, Inc. is not a liated with TomTom International NV.

Do not place mount in or near an air bag deployment zone

or where it will obstruct view of the road.

Dash or Console Mounting (Optional)

Step 1.

Find a safe location on the dash or console. Use the included alcohol pad to clean the mounting surface if necessary. Remove the paper backing on the adhesive disc and  rmly press in place.

Step 2.

Place the pedestal’s suction base (A) over the center of the circular disc. While  rmly holding the pedestal on top of the disc,  ip the base lever down (B) to the locked position.

TomTom GO Adapter Plate Installation

Step 1. Attach the adapter plate by sliding it up into the slot on the

back of the TomTom GO 520, 530, 720, 730, 920, 920T or 930 device as shown. Attach the device as shown below.

Safety Precautions

Do not install Arkon products over an air bag cover or within the air bag deployment zone. Arkon Resources, Inc. assumes no responsibility of liability for injury or death as a result of car crashes and / or air bag deployment.

Arkon is not responsible for any damages caused to your car, your device, or yourself due to the installation or use of this pedestal mount.

TomTom GO Series Device Attachment

Step 1.

Attach the device and adapter plate to the mount by inserting the dual T-tabs of the mount (D) into the T-slots of the adapter plate (E). Adjust the angle of the head by tightening the head adjustment knob (F).

The Mobile Mounting Specialists™

Consumer Hotline:

USA (800) 841-0884 INT’L (626) 254-9005

Monday - Friday 9 am - 5 pm, PST

Designed in USA | Made in Taiwan

www.arkon.com

Arcadia, CA 91006 USA