Arkon MP070-7PS-1, MP070-7PS-2 User Manual

MP070-7PS-2 & MP070-7PS-1 7" Modular Windshield Suction Pedestal

MP070-7PS-1 with a single T-tab is also available with the same set of
instructions listed below.

MP070-7PS-2

Dash Installation (Optional,
when disc is included)

Step 1.

Locate a safe flat surface on
the dash or console to mount
the pedestal. Clean the dash
with the alcohol pad
provided. Dry the surface
before applying the adhesive
disc (C).

(A)

(B)

Pedestal

Shaft

(B)

(A)

Windshield Installation

Step 1.

Push the pedestal suction cup (A) firmly to the windshield.
Flip the lever (B) down to secure the suction cup.

(D)

Pedestal Adjustment

Step 1.

Adjust the vertical angle of the pedestal shaft by 180° and
the swivel rotation by 360° by loosening the adjustment

.

knob (D). Adjust the lateral angle of the dual T-head (F) by
180° and the rotation by 360° by loosening the adjustment
knob (E).

(E)

(F)

(C)

Device Cradle Installation

Step 1.

Attach the device cradle to the pedestal by inserting the dual T­tabs (F) of the pedestal into the T-slots of the cradle (G). (cradles

are sold separately and vary depending on the device you are using)

(F)

Push the pedestal suction cup

Step 2.

(A) firmly to the disc (C). Flip
the lever (B) down to secure
the suction cup.

(G)

Safety Precautions

Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no
responsibility of liability for injury or death as a result of car crashes
and/or air bag deployment.

Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.

Consumer Hotline:
(USA) [phone]
(INT'L) [phone]
Mon-Fri. 9am-5pm, PST

The Mobile Mounting Specialists

Arcadia, CA 91006 USA

© Copyright 2007 Arkon Resources, Inc.

TM

www.arkon.com

Made in Taiwan