A-rival sQip User Manual
Device Overview
Important Notice
Installation
This device can also be installed in shoes that come with
insertion slot for this sensor, such as Nike or Adidas shoes with
special feature marks.
(Lift up sock liner and insert this sensor into the slot with LOGO
facing up)
Clip
To install the clip, slide the clip forward along
the back of the sensor until the sensor is
securely snapped into the clip latch.
This device can be clipped onto shirt pocket, collar or
around waist. Please make sure the device is securely
snapped into the clip before use.
To detach the clip from the sensor,
pull up the clip latch in order to
eject the sensor.
User Manual
Pedometer
The device comes with a battery pre-inserted.
Before using the device, the insulation sheet
must be removed in order to use the device.
Please remove the insulation sheet as shown
in the image illustrated. (Improper removal of
the insulation sheet might end up breaking
the insulation sheet.) Once the battery fails to
activate, you will need to open the battery
cover, and remove scraps of the broken
sheet.
Rear Side
Shoelace Hole
Screw
Front Side
Insulation Sheet
Insulation Sheet
Battery Cover
Front Side
Install Device into the Slot of the Sneaker
Important Notice
While tying the shoelace, pull one through
from upward while the other from
downward, and make sure the front side
faces up.
Please try to keep the device at horizontal
level, for excessive tilting might cause
incorrect detection.
When the device is tightened on the shoelace, make sure the front side faces up, while
the shoelace should be pulled through the two shoelace holes aside the device and tied
with a knot to fasten the device
Use clip Install & Uninstall Clip
Install the sensor on top of Sneakers
Front-side facing down
Excessive tilting
1b
1a
1c
2
Download and install the a-rival app
Supported Devices:
Any Android (v4.3 and up suggested) mobile phone with built-in
4.0 Bluetooth or iOS device, such as iPhone 4S/5/5S/5C, iPad
mini/4 or iPod Touch 5.
Notes:
Although the device is useable in the rain, it is prohibited to be
used under water.
Please do not use any corrosive chemical to clean the device.
Bluetooth is disabled by default. Bluetooth will be activated
automatically upon detection of any sensor movement.
1.
2.
3.
For Android phone users, please download a-rival app from Google Play. For iOS phone users, please download a-rival app from App Store.
1.
2.
1.
2.
3.
4.
5.
6.
Step 1. Set up personal profile
Open the a-rival app on your phone.
Select [Profil], and fill in your personal information like
Name, Gender, Height, Weight and Age
Step 2. Scan for device and complete device calibration
Open the a-rival app on your phone, and tap on the Shoepod section.
The app will start device search. Once your device is found, tap on
Footpod shown in the section of Detected sensor(s) to get connected,
and tap on. Afterwards to proceed with device calibration. (To start with
calibration, you’ll be guided via a wizard. Follow what’s stated on the
screen to complete the procedures.)
Properly install your device by either placing it in the shoe or on the shoe
as illustrated on the screen. Please stand still while placing the device,
then tap on [Next] to continue.
Stand on your tiptoe as illustrated. Tap on [Next] to continue.
Calibration is now complete, and the app has detected the position of your
device as illustrated on the screen.
You may now start using a-rival with the device installed.
Important Notice:
In order to ensure the accuracy of detection, the device must be calibrated every
time it is installed.
Battery Change
Use a screw driver to loosen the screws on the battery cover.
Please have the screws kept somewhere.
Remove the battery cover.
Insert an CR2032 coin battery.
Close it with the battery cover.
Please insert the battery with the positive electrode facing down.
Please make sure the screws on the battery cover are securely
fastened, in case of any water penetration.
1.
2.
Getting Started : To get started with sQip, please complete the following settings:
Important Notice
+
Loading...