Aries Automotive S229007-2 User Manual

INSTALLATION INSTRUCTIONS

OVAL TUBE

229006 / 229006-2 NISSAN TITAN CREW CAB

229007,229007-2 NISSAN TITAN EXT. CAB

PARTS LIST

(1) Aries Side bar – passenger side (12) 3/8”x1’’ button head bolts
(1) Aries Side Bar – Driver side (12) 3/8’’sae black flat washers
(2) Front mount brackets (12) 5/16’’ USS zinc flat washer
(2) Middle mount brackets (6) 8mm 1.25 x 25mm zinc hex bolt
(2) Rear mount brackets (6) 8mm 1.25 zinc nut

PROCEDURE

1. Begin installation by working on driver side of the vehicle starting at the front of
the inner

2. Located on the inside as well as the bottom inner of the rocker panel you will see
one thread hole and one thread stud for each mounting bracket refer to diagram

1.(Note all brackets are labeled )

3. Install mounting brackets to inner rocker panel using 8mm 1.25 x 25 mm bolts
plus 8mm nuts and washers as shown in diagram 2.Hand tighten only.

4. Attach side bar to brackets using the 3/8” button head bolts and washers. Align
the side bar with the vehicle body, then tighten & torque all fasteners to:
(30ft/lbs). Repeat steps for passenger side to complete installation.

DIAGRAM 1. DIAGRAM 2.

rocker panel.

FINISH PROTECTION- ARIES PRODUCTS HAVE A HIGH FINISH THAT MUST BE MAINTAINED SUCH AS ANY
OTHER HIGH FINISH PRODUCT ON THE VEHICLE. PROTECT THE FINISH WITH A NON-ABRASIVE AUTOMOTIVE
WAX. THE USE OF SOAP, POLISH, OR WAX THAT CONTAINS ABRASIVES IS DETRIMENTAL, AS THE COMPOUNDS
SCRATCH THE FINISH AND OPEN IT TO CORROSION.

DISCLAIMER- BUYER ASSUMES ALL RISK AND LIABILITY WHATSOEVER FROM THE INSTALLATION
AND USE OF ARIES PRODUCTS. ARIES PRODUCTS ARE SOLD AS DECORATIVE ACCESSORIES AND
SHOULD NOT BE RELIED UPON AS PROTECTION FOR THE VEHICLE OR OCCUPANTS IN THE EVENT OF
A COLLISION OR ROLL OVER. ARIES AUTOMOTIVE ASSUMES NO LIABILITY FOR INJURY, LOSS,
INCIDENTAL OR CONSEQUENTIAL DAMAGES IN THE EVENT OF A COLLISION OR ROLLOVER.