Aries Automotive B35-9003 User Manual

PARTS LIST:

1 Bull Bar 4 12-1.25mm Hex Head Bolts
1 Driver/Left Mounting Bracket 4 12-1.75mm Hex Head Bolts
1 Passenger/Right Mounting Bracket 4 12mm Hex Nuts

12 12mm ID x 29mm OD x 3mm Flat Washers

INSTALLATION INSTRUCTIONS

2008-12 PATHFINDER

PART # B35-9003 / 35-9003

Driver Side

Mounting

Bracket

Passenger

Side

Mounting

Bracket

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.

2. From underside of vehicle, use a10mm socket wrench to

center plastic shroud on a clean working area and use a hack saw to cut out the driver side to w hook cavity
(Figure 1).

remove the 6 bolts holding the center plastic shroud. Set

3. Remove the factory tow hook located on the passenger side (Figure 2). NOTE: You will not be re-installing tow
hook.

Locate the passenger side Mounting Bracket and partially hang it from factory threaded holes on the frame rail

4.

using the included (2) 12-1.25 x 35mm Hex Head Bolts (fine thread), (2) 12mm Lock Washers, and (2) 12mm Flat
Washers (Figure 3). Repeat this step for driver side.

Reinstall it back to

5.

6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting Brackets using the

included (4) 12-1.75mm x 30mm Hex Head Bolts, (4) 12mm Lock Washers, (4) 12mm Hex Nuts, and (8) 12mm
Flat Washers (Figure 4).

7. Align Bull Bar properly and then tighten all hardware.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer

over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be

used also to clean the Product.

For gloss black finishes

Page 1 of 2

the vehicle using the same

: Mild soap may be used to clean the Product.

factory hardware.

Cutout the driver
side tow hook cavity

Fig 1

(Passenger Side Installation Shown)

Fig 2 Fig 3

Remove Factory

Tow Hooks Bolts

Bull bar attached w/o shroud for install view

Fig 4 Fig 5

12-1.75mm x 35mm Hex Bolts
12mm Lock Washers
12mm Hex Nuts
12mm Flat Washers

Center plastic shroud

Replace factory bolts with the
included:
12-1.25 x 35mm Hex Bolts
12mm Lock Washers
12mm Flat Washers

Page 2 of 2