Aries Automotive B35-3006 User Manual

INSTALLATION INSTRUCTIONS

BULL BAR

PARTS LIST:

1 Bull Bar
1 Driver/Left side Mounting Bracket
1 Passenger/Right Mounting Bracket
4 3/8” x 1 ¼” Hex Head Bolts
4 3/8” Nylock Nuts
8 3/8” Flat Washers

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It

is not required, but strongly recommended. If local/state law requires a license plate, license
plate relocation kit is available.

3. From front of vehicle remove the driver side bumper mount bolts (Figure 2).
WARNING! Do not remove passenger and driver bumper mount bolts at the same time.
Remove one side at a time.

4. Place Mounting Bracket onto vehicle and line it up against the outer gusset bend on the frame.

Leave about 1/8” clearance between bottom of Mounting Bracket and bumper. Secure
Mounting Bracket to vehicle using the factory bolts (Figure 3). Fully tighten these bolts at this
time.

5. Once the driver side Mounting Bracket is fully tightened, repeat steps 2 - 4 for passenger side
Mounting Bracket.

6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting
Brackets using the included (4) 3/8” x 1 ¼” Hex Head Bolts, (4) 3/8” Nylock Nuts, and (8) 3/8”
Flat Washers (Figure 4). Do not tighten at this time.

7. Level and adjust Bull Bar as desired, then tighten all hardware at this time.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight..

Passenger Side

Mounting Bracket

2008-10 SUPER DUTY F250/F350

PART# B35-3006 / 35-3006

Figure 1

Driver Side

Mounting Bracket

Page 1 of 2

Remove these

factory bolts

Driver side

Mounting Bracket

Factory Bolts

Figure 2 Figure 3

3/8” x 1 ¼” Hex Head

Bolts,

3/8” Nylock Nut, &

3/8” Flat Washers

Figure 4

Installation Complete

Figure 5

Page 2 of 2