Aries Automotive 75-0000 User Manual

INSTALLATION INSTRUCTIONS

2011/2012 Fiat License Plate Relocator

PARTS LIST:

Qty Description Qty Description

1 Mount Bracket 1 8mm x 20mm Hex Bolt
1 License plate X holder 1 8mm Lock Washer
6 6mm x 25mm Hex Bolt 1 8mm Hex Nut

12 6mm Flat Washer 2 8mm Flat Washer

6 6mm lock washers

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Begin installation by removing License plate & factory holder (if equipped)

3. Once removed begin installation by locating & removing the 2 factory bolts just under the
front bumper lip on passenger right side vehicle (Fig 1) shows location of factory bolts.

4. With these two bolts removed select the Mount Bracket above and secure to the bumper lip

with the (2) 6mm x 25mm Hex bolts & (2) 6mm flat washers & (2) 6mm lock washers as
seen in (Fig 2). Snug but do not tighten hardware at this time.

5. Attach and secure the License plate X holder to the mount bracket you have just installed
with the (1) 8mm x 20mm Hex bolt, (2) 8mm flat washers, (1) 8mm lock washer & (1) 8mm
Hex nut Note: there are 3 holes for various position for you to choose, when you have
selected to which hole you will use tighten all hardware.

Mounting Brackets

Part # 75-0000

License plate X holder

Page 1 of 2 12/2/2011

6. Next, select your License plate and secure it to the Holder with the (4) 6mm x 25mm Hex
bolt, (4) 6mm flat washers & (4) 6mm lock washers, from the list of parts above, (Fig 3)
shows installation complete.

7. Do periodic inspections to the installation to make sure all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended

to add a protective layer over the finish. Do not use any type of polish or wax that may contain
abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the
finish. Mild soap may be used also to clean the Sidebar.

For gloss black finishes: Mild soap may be used to clean the Sidebar.

Fig 1

Fig 2

Mount bracket

Remove factory bolts

Secure
with 6mm
hardware

Fig 3

Page 2 of 2 12/2/2011