Aries Automotive 55-0000 User Manual

INSTALLATION INSTRUCTIONS

PARTS LIST:

Qty Description Qty Description

1 License plate relocator 1 8mm x 35mm Hex bolt
1 Nut plate mounting bracket 1 8mm lock washer
1 8mm x 75mm Hex bolt 4 6.5mm ID X 20mm OD flat washers
4 6mm x 20mm button head bolts

License plate relocator

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Start by placing the nut plate behind the bumper with the nut facing to the back, once insert Attach

& secure the License plate relocator with (1) 8mm lock washers & (1) 8mm x 75mm Hex bolt as
seen in (Fig 1) Level and adjust the license plate relocator to the bumper and tighten all hardware
attaché your license plate with (4) 6mm button head bolts & (4) 6.5mm flat washers.

To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.

2007-11 Wrangler license plate relocator used with 15600 bumper

Fig 1

1976-06 CJ / YJ Wrangler Front Tubular Bumpers

2007-11 JK Wrangler Front Tubular Bumpers

PART # 55-0000

Nut plate mounting bracket

Secure with
(1) 8mm x 75mm hex bolt

PROCEDURE:

3. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

4. Start by inserting the nut plate into the opening on the bumper, as seen in (Fig 1) once insert as

seen in (Fig 2) Attach & secure the License plate relocator with (1) 8mm lock washers & (1) 8mm
x 35mm Hex bolt as seen in (Fig 3) Level and adjust the license plate relocator to the bumper and
tighten all hardware attaché your license plate with (4) 6mm button head bolts & (4) 6.5mm flat
washers.

To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.

2007-11 Wrangler used with 15600 bumpers

Fig 1

Location of nut plate

Nut Plate

Fig 2 Fig 3

Installation complete

Hold plate in place

Secure with
(1) 8mm x 35mm hex bolt
(1) 8mm flat washer