Aries Automotive 5056-2 User Manual

INSTALLATION INSTRUCTIONS

PARTS LIST:

Qty Description Qty Description

1 Grill Guard Bar 8 10mm Nut
1 Driver/Left Mounting Bracket 6 12mm x 30mm Hex Bolt
1 Passenger/Right Mounting Bracket 12 12mm Flat washer

8 10mm x 60mm Hex Bolt 6 12mm Lock Washer
16 10mm Flat Washers 6 12mm Nut
16 10mm Lock Washers

Passenger/right
side mounting
bracket

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Starting with the Passenger/Right side Proceed with your install by removing the factory tow

hook of the vehicle, slide the mounting bracket behind the tow hook and secure tow hook and
mount bracket with the supplied (4) 10mm x 60mm hex bolt, (8) 10mm flat washers (4) 10mm
lock washers (4) 10mm nut (Fig 1) shows mount bracket & tow hook attached. Snug but do not
tighten hardware at this time. Repeat this step for the driver/Left side installation.

3. With help begin to install Grille Guard, move the Passenger/Right side and Driver/Left side
Mounting Brackets in as far as possible, and (loosen hardware slightly if necessary). Position
the Grille Guard up to the Outer side of the Passenger/Right side Mounting Bracket and line up
the mounting holes in the Mounting Bracket with the holes in the Grille Guard, bolt together
with the included (3) 12mm x 30mm Hex bolts (6) 12mm flat Washer, (3) 12mm lock washers
and (3) 12mm Hex Nut, Repeat this step for the Driver/left side. (Fig 2) shows grill guard
attached to mount brackets, Snug but do not tighten hardware at this time.

4. Adjust the Grille Guard as required for alignment. Tighten all mounting brackets & tow hook
hardware, your install is now completed.

5. Do periodic inspections to the installation to make sure all hardware is secure and tight.

2010 Dodge Ram P/U 2500/3500 2/4WD

NOTE: (tow hooks will be re-attached)

5056 / 5056-2

Driver/left side
mounting
bracket

Page 1 of 2 1/26/2010