Aries Automotive 45-4011 User Manual

2011 SILVERADO HD 2500-3500 & 2011 SIERRA HD 2500-3500

PARTS LIST:

1 Bull Bar 8 10mm ID x 26mm OD x 3mm Flat Washers
1 Driver/Left Frame Bracket 4 12-1.75mm x 35mm Hex Head Bolts
1 Passenger/Right Frame Bracket 4 12mm Lock Washers
4 10mm x 30mm Hex Head Bolts 4 12mm Hex Nuts
4 10mm Lock Washers 8 12mm ID x 29mm OD x 3mm Flat Washers
4 10mm Hex Nuts

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It

3. From underside of vehicle, remove the two bolts holding the Driver factory tow hook, then

4. Repeat steps for Passenger side Frame Bracket.

5. With help position & loosely attach Bull Bar to brackets using the included (4) 10mm x 30mm

6. Level and adjust Bull Bar, then tighten all hardware at this time.

7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

Passenger Side Frame Bracket Driver Side Frame Bracket

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

is not required, but strongly recommended. If local Prov. / State law requires a license plate,
license plate relocation kit is available.

remove tow hook from vehicle. NOTE: This Bull Bar is not compatible with factory tow hooks,
so you will not be reinstalling factory tow hooks back onto vehicle. Determine driver and Driver
Frame Brackets. NOTE: Refer to Figure above for bracket configuration. Position Driver side
Frame Bracket to the outside of the frame rail and secure using the included (2) 12mm x
35mm Hex Head Bolts, (2) 12mm lock Washers, (2) 12mm Hex Nuts, and (4) 12mm Flat
Washers (Fig 1). Snug but do not tighten at this time.

Hex Head Bolts, (4) 10mm Lock Washers, and (4) 10mm Flat Washers (Fig 2).shows
Passenger side Snug but do not tighten at this time.

INSTALLATION INSTRUCTIONS

4” BIG HORN BULL BAR

45-4011

Page 1 of 2

To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Product.

For gloss black finishes: Mild soap may be used to clean the Product.

Driver side shown

Fig 2

12mm x 35mm Hex Head Bolts
12mm Lock Washers
12mm Hex Nuts
12mm Flat Washers

(2) 10mm x 30mm Hex Head Bolts
(2) 10mm Lock Washers
(4) 10mm Flat Washers
(2) 10mm Nuts

Installation Complete

Page 2 of 2