Aries Automotive 45-3012 User Manual

INSTALLATION INSTRUCTIONS

BIG HORN BULL BAR

PARTS LIST:

1 Bull Bar
1 Driver/Left side Mounting Bracket
1 Passenger/Right Mounting Bracket

4 10mm x 30mm Hex Head Bolts
4 10mm Nuts
8 10mm Flat Washers

PROCEDURE:

8 10mm Lock Washers

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. NOTE: It may be necessary to remove/relocate front license plate and license plate bracket. It

is not required, but strongly recommended. If local/state law requires a license plate, license
plate relocation kit is available.

3. From front of vehicle remove the driver side bumper mount bolts (Figure 2).
WARNING! Do not remove passenger and driver bumper mount bolts at the same time.
Remove one side at a time.

4. Place Mounting Bracket onto vehicle and line it up against the outer gusset bend on the frame.

Leave about 1/8” clearance between bottom of Mounting Bracket and bumper. Secure
Mounting Bracket to vehicle using the factory bolts (Figure 3). Fully tighten these bolts at this
time.

5. Once the driver side Mounting Bracket is fully tightened, repeat steps 2 - 4 for passenger side
Mounting Bracket.

6. With help position Bull Bar on the outer side of Mounting Brackets. Attach Bull Bar to Mounting

Washers and 1Omm lock washers (Figure 4). Do

7. Level and adjust Bull Bar as desired, then tighten all hardware at this time.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight..

Passenger Side

Mounting Bracket

2011 FORD SUPER DUTY 350-550

PART NUMBER 45-3012

Hex Bolts, (4) 1Omm Nuts, (8) 1Omm flat Brackets using the included (4) 1Omm x 3Omm

not tighten at this time.

Driver Side

Mounting Bracket

Figure 1

Page 1 of 2

10mm x 30mm Hex Bolts

10mm Flat Washers
10mm Lock wahers

10mm Nuts

Remove these

factory bolts

Figure 2 Figure 3

Mounting Bracket

Figure 4

Installation Complete

Figure 5

Driver side

Factory Bolts

Page 2 of 2