Aries Automotive 4501 User Manual
INSTALLATION INSTRUCTION
ITEM NO:4501
APPLICATION:Dodge Ram 1500-Quad Cab 2002-2008
ATTENTION
1.Please read this installation instruction before installing this part.
When install it,please pay attention to protecting your vehicles.
2.When you use it,please check this parts at a fix time-lapse,such as one
month or two month.
PARTS LIST
No
mount bracket
A
front bracket
B
rear bracket
C
support bracket
D
E
F
flat washer
G
Name
Hex Bolt
45mm spacer
Photo
Qty
2
2
2
2
4
4
4
Remarks Remarks
LATERAL
SYMMETRY
LATERAL
SYMMETRY
LATERAL
SYMMETRY
LATERAL
SYMMETRY
M12X120
12mm
12mm
J
Hex Bolt
flat washer
K
Lock washer
L
M
Hex Nut
Plastic push
N
O
"T"Bolt
P
NameNo
Flat washer
Photo
Qty
4
12
8
8
4
4
16
M10X30
10mm
10mm
M10
10mm
M6
Lock washer
H
"T" Bolt
I
4
4
12mm
M10X25
I
LOCK NUT
16
M6
Page 1 of 2
INSTALLATION STEPS
Fig.A
Factory Bushing
Inside Eocker panel
IKLMN
B
g
.
F
i
B
FGH
JKLM
Driver Side
D
F
C
A
EFGH
IKLMN
JKLM
IKLMN
t
n
o
r
O
I
P
INSTALLATION STEPS
STEP 1.Remove all contents from the received box and check stainless steel tube for any dent.Also verify all
brackets and bolts against the parts list.
STEP 2.Read installation manual and istallation drawing completely.Understand all brackets and bolts before
installation.
STEP 3.Remove the body mount bolts from the front and rear body mounts underneath cab of truck and discard.
(Keep the factory bolts and bushings) Loosely bolt front bracket to front body mount using the (E F G H)
as shown (Fig.A).(Make sure factory bushing is put on the same way is taken off.)
STEP 4.Loosely bolts rear brackets to rear body mounts using the (E F G H) as shown (Fig.A).(Make sure factory
bushing is put on the same way is taken off.)
STEP 5.Insert (I) in front inside of pinch weld and hold in place with Push-nut(M).Mount front support brace to
T-bolt using flat(K),lock(L)washers and hex head nut(M) as shown .Attach rear support brace to rear
bracket using hex bolt(J),flat(K)and lock(L) washers,and hex head nut(M) as shown in Fig.A.
STEP 6.Insert T-bolt(I) in rear inside of pinch weld and hold in place with Push-nut(M).Mount front support
brace to T-bolt using flat(K),lock(L)washers and hex head nut(M) as shown Fig.B.Attach rear support
brace to rear bracket using hex bolt(J),flat(K)and lock(L) washers,and hex head nut(M) as shown in Fig.A.
STEP 7.Mount step bar to front and rear brackets using T bolt(O),nut(I),flat(P)washers as shown.Head
tighten into nutsert on the bottom of the step bar.Adjust position of step bar and tighten all bolts.
Page 2 of 2
Loading...