Aries Automotive 4066-2 User Manual

INSTALLATION INSTRUCTIONS

4066/4066-2

2007 CADILLAC ESCALADE GRILL/BRUSH GUARD

HARDWARE KIT:
(1) GRILL GUARD
(2) BRACKETS
(2) BOTTOM BRACKETS
(2) BOTTOM END BRACKETS
(10)M12 X 30mm HEX HEAD BOLTS
(24)M12 FLAT WASHERS
(12)M12 NYLOC HEX NUTS
(2) M12 X 120mm HEX HEAD BOLTS
(2) M6X 20 HEX HEAD BOLTS

PROCEDURE:

1- REMOVE CONTENTS FROM BOX AND CHECK FOR DAMAGE. VERIFY

ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.

2- REMOVE (2) PLASTIC RETAINER TOWHOOK COVERS LOCATED AT

LOWER END OF FRONT BUMPER (PASSENGER SIDE SHOWN) SEE
FIG#1

3- INSTALL (1) BOTTOM BRACKET (1) BOTTOM END BRACKET USING (2)

M12 X 30mm HEX HEAD BOLTS (2) M12 NYLOC HEX NUT (4) M12 FLAT
WASHERS. THEN INSTALL (1) M12 X 120mm HEX HEAD BOLT (1) M12
NYLOC NUT (2) M12 FLAT WASHERS, ADJUST BOTTOM BRACKET
DOWN THEN TIGHTEN. (DRIVER SIDE SHOWN) SEE FIG.# 2

NOTE:
HEAD BOLTS (2) M12 NYLOC HEX HEAD NUTS (4) M12 FLAT
WASHERS FROM HARDWARE KIT AND USE EXISTING TOWHOOKS
AND HARD WARE FOR BOTTOM AND BOTTOM END BRACKET
INTALLATION.

4- REPEAT PROCEDURE #3 ON OPPOSITE SIDE.
5- INSTALL GRILL GUARD ON TO DRIVER AND PASSENGER BOTTOM

BRACKET ASSEMBLIES USING (6) M12 X 30 HEX HEAD BOLTS (6) M12
NYLOC NUTS (12) M12 FLAT WASHERS LEAVE LOOSE, SEE FIG. #2
(DRIVER SIDE SHOWN).

6- OPEN HOOD FOR ACCESS, REMOVE (2) EXISTING BOLTS LOCATED

INSIDE OF GRILL MOUNT AND SET ASIDE (DRIVER SIDE SHOWN) SEE
FIG #3. INSTALL DRIVER/PASSENGER TOP BRACKET USING EXISTING
BOLTS. THEN BOLT TOP BRACKETS (DRIVER/PASSENGER) ON TO

FOR EXISTING TOWHOOKS. REMOVE (2) M12 X 30mm HEX

GRILL GUARD USING (2) M6 X 20mm HEX HEAD BOLTS LEAVE LOOSE.
SEE FIG # 3.

7- LEVEL AND ADJUST GRILL GUARD AS DESIRED AND TIGHTEN.

PLASTIC RETAINER

TOWHOOK COVER

FIG# 1

FIG #2

M12 X 30 mm

HARDWARE

M12 X 120mm
HARDWARE

PASSENGER SIDE

SHOWN

M12 X 30mm HARDWARE

EXISTING BOLTS

FIG #3

GRILL MOUNT

EXISTING BOLT

TOP BRACKET