Aries Automotive 302505 User Manual

y

INSTALLATION INSTRUCTIONS

REAR BUMPER PART # B302505/302505

PARTS LIST:

Qty Description Qty Description

1 Rear Bumper 2 Flat Washers
2 Reflector Safety Stickers 2 Lock Washers
2 Driver & Passenger Tow Hook Bolt 2 Spacers

Reflector

stickers

Safet

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Begin the install by removing the 2 plastic hole plugs covering the tow hook threads on the

back bumper (Fig 1) select the (2) flat washers (2) lock washers, (2) Tow hook bolts and the
(2) spacers, from the parts above.

Back Bumper

1998-2007 405 SMART CAR
1999-2010 451 SMART CAR

Tow Hook

Bolt

Spacers

Page 1 of 2 5/3/2010

3. Slide (1) lock washers followed by (1) flat washer over each tow hook bolt, and with help slide
the tow hook bolts threw the back bumper followed by the spacers, ounce done lift the back
bumper up to the rear bumper of the car, proceed to then fasten the back bumper to the car.
Snug but do not tighten hardware at this time. (Fig 2 & Fig 2A) Shows bumper guard installed
to vehicle.

4. Align back bumper properly, and then tighten all hardware.

5. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to

add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.

For gloss black finishes: Mild soap may be used to clean the Sidebar.

FIG 1

FIG 2

Factory
Plastic hole
plugs

450 Model shown

FIG 2A

451 Model shown

Page 2 of 2 5/3/2010