Aries Automotive 25630BK User Manual

PARTS LIST:
4 Brace Brackets
8mm Clip nuts 8
INSTALLATION INSTRUCTIONS
2007 -12 J K TIRE CARRIER RE-INF ORCEMENT
PART # 25 6 30B K
8mm x 60mm Hex Bolts 2
8mm Clip Nuts
STARTING INSTALLATION.
Brace Brackets
. .
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE
Start by removing the factory tire, with the tire removed open the rear door and remove the
2.
plastic panel on the the door this will expose the third brake light wire as seen in
3.
Select the 8mm x 60mm bolt from the kit and thread it a few turns into one of the 8mm nut
(Fig 2 & 3)
(Fig 4)
Also remove the plastic cover on the door which was behind the tire carrier.
which held the tire carrier inplace, bend the bolt up,down and side to side to break the spot welds
on the nut remove nut from bolt and proceed to remove the remaing 7 nuts
(Fig 5)
NOTE: The kit comes with 2 8mm x 60mm bolt incase one breaks.
Next slide the clip nuts onto either side of the brace brackets as seen in
4.
(Fig 6)
with help place the tire carrier back into place and begin to place the brace brackets in through the plastic cover removed in step 2 attach the tire carrier back onto door with the factory bolts
into the brace bracket Snug but do not tighten at this time as seen in
(Figs 7)
With the the tire carrier re-attached place the plastic cover back into the door.5. place the brake light wire back into the hole of the door and push in the rubber plug, plug in the brake light to the wire harness and place the plastic cover back onto the door
as seen in .
(Fig 1, 2 & 3)
.
(Fig 1)
(Fig 8)
Page 1 of 2
.
r
d
d
Fig 1
Remove plastic louvered cove
Fig 2
Unplug rear 3 brake light
r
Fig 3 Fig 4
Remove rear 3 brake light wire
r
Fig 5
Fig 6
Remove factory tire carrier bolts
tire carrier bolts
Remove factory
Fig 7
Fig 8
Page 2 of 2
Loading...