Aries Automotive 25600 User Manual

INSTALLATION INSTRUCTIONS

r

per

2007-11 WRANGLER BACK REPLACEMENT BUMPER

PART # 25600

PARTS LIST:

Qty Description Qty Description

1 Center section rear bumper 24 10mm Flat Washers
1 Passenger/Right side bumper corner 14 10mm Lock Washers
1 Driver/Left side bumper corner 10 10mm Nuts
1 Passenger/Right side bumper corner bracket 2 12mm Nut Plates
1 Driver/Left side bumper corner bracket 4 12mm x 35mm Hex Bolts

10 10mm x 40mm Button Head Bolts 4 12mm Flat Washers

4 10mm x 35mm Hex Bolts 4 12mm Lock Washers

Center Section

Rear Bum

Driver/Left

Side Corner

12mm Nut Plates

Driver/Left

Side Bumper

Corner Bracket

Passenger/Right

Side Bumper

corner Bracket

Passenger/Right

Side Corne

Page 1 of 4

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Start by removing the (2) 10mm fasteners holding the corners of the bumper support bracket to

the frame, they are located on the inner rear of wheel wells (Fig 1) shows passenger right side
bolts, Repeat for Driver/Left side with these bolts removed begin to remove the center bumper
bolts holding the Z brackets located just up & behind the cross bar, 2 bolts per Z brackets as seen
in (Fig 1A) shows passenger side Z bracket. (Fig 1B) shows zoomed in view of passenger side Z
bracket. Repeat for Driver/Left side

3. With the brackets removed you can now remove the rear bumper. Once the bumper is removed
begin to remove the rear tow hook, this will not be reinstalled. (Fig 2) shows tow hook removal.

4. With help, Select the new Center Bumper section and place it up and into place securing it to
vehicles frame by placing the 12mm nut plate through the opening of the Aries bumper up & into
place securing with (2) 12mm hex bolts, (2) 12mm flat washers and (2) 12mm lock (Fig 3) shows
Driver side nut plate inserted into frame rails. Repeat for Passenger/Right side, Snug but do not
tighten hardware. (Fig 3A) shows Driver/Left side bumper secured to nut plate with 12mm
hardware.

5. Next select the bumper corner brackets from the list of parts above and secure with (2) 10mm x
35mm Hex bolts (2) 10mm flat washers and (2) 10mm lock washers, Snug but do not tighten
hardware. (Fig 4) shows passenger side installed. Repeat for Driver/left side. Snug but do not
tighten hardware

6. With the corner brackets attached begin to install the bumper corners with the 10mm button head
bolts and 10mm fasteners. (Fig 5) shows passenger side installed Top View shown (Fig 5A & 5B)
shows passenger side installed Bottom View shown, Repeat for Driver/left side. Snug but do not
tighten hardware.

7. Level and adjust the bumper and tighten all hardware.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to

add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.

For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Product.

For gloss black finishes: Mild soap may be used to clean the Product.

Page 2 of 4