Aries Automotive 25009 User Manual

PARTS LIST:

Qty Description Qty Description

1 Driver/Left Door 4 8mm Flat Washers
1 Passenger/right Door 2 Rubber Bushing
4 8mm Lock Nuts 2 Philips Head Sheet Metal Screws

PROCEDURE:

Passenger/right side
Rear Door

1.

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.

2. Starting on the Rear Passenger side of vehicle remove the (2) factory 50mm Torque bolts securing

the doors onto the hinges, as seen below in (Fig 1). Locate the lower kick panel as seen in (Fig 2)
remove the plastic cover with a flat tipped screw driver exposing the dome light wire harness
disconnect wire by pulling the red clip back and unplugging the dome light wire from the harness
as seen in (Fig 3) followed by removing the swing out safety strap, seen in (Fig 4). Once removed
lift off the door and place it off to the side.

3. With the factory door removed select your new passenger/right side tubular door slide the door
pins into the factory hinges & secure the doors with (2) 8mm Flat washers & (2) 8mm Lock Nuts as
seen in (Fig 5) Snug the hardware but do not tighten at this time, before closing the door select the
rubber bushing and attach to the inner tube with the Philips head sheet metal screw where the
inner latch is on the door jam seen in (Fig 6), check the alignment of the locking door latch with the
striker plate inside the door jam of the vehicle seen in (Fig 7) (this may need to be adjusted so that
the door closes completely) if it needs adjustment loosen the toque bolts on the door jam of the
Jeep and align with the door latch on the tubular doors, once in alignment tighten the torque
fasteners check to see that the door completely locks before continuing to the next step.

INSTALLATION INSTRUCTIONS

2007-13 JEEP JK REAR ALUMINUM TUBULAR DOORS

PART# 25009

Driver/left side
Rear Door

NOTE:

Page 1 of 3

4. Repeat steps 2 through 3 for Driver/left side installation.

5. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a

protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.

For gloss black finishes: Mild soap may be used to clean the Product.

Fig 1

Passenger side shown

Fig 2

Flat tipped
screw driver

Remove (2)
Torque bolts

Remove
plastic cover

Fig 3

Fig 4

Remove dome
light wire

Remove swing
out safety strap

Page 2 of 3