
INSTALLATION INSTRUCTIONS
PARTS LIST:
Qty Description Qty Description
1 Driver/Left Sidebar 1 Driver/Left Rear Mounting Bracket
1 Passenger/Right Sidebar 1 Passenger/Right Rear Mounting Bracket
1 Driver/Left Front Mounting Bracket 12 10mm x 30mm Hex head Bolts
1 Passenger/Right Front Mounting Bracket 12 10mm Flat washers
1 Driver/Left Middle Mounting Bracket 12 10mm Lock washers
1 Passenger/Right Middle Mounting Bracket
Passenger/Right
Front Mounting
Drive/left Side
Front
Mounting Bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting at the Passenger/Right side-front of the vehicle, remove the front factory body bolt &
washer From the list above select the Passenger/Right side front mounting bracket and secure
to vehicle with factory Hex Bolt,12mm Flat Washer, & Lock Washers (Fig 1). Snug but do not
tighten hardware at this time.
3. Moving to the Passenger/Right side middle of the vehicle, remove the front factory body bolt &
washer. From the list above select the Passenger/Right side Middle mounting bracket and
secure to vehicle with factory Hex Bolt, Flat Washer, Lock Washers (Fig 2). Snug but do not
tighten hardware at this time.
2000-12 Silverado HD crew cab
2000-12 Sierra HD crew cab
P ART# 224013/224013-2
Drive/left Side
Middle
Mount Bracket
Passenger/right
Side Middle
Passenger/ Right
Rear Mounting
Driver/ Left Rear
Mounting Bracket
Page 1 of 3 10/4/2010)

4. Remove the passenger/Right side rear factory body bolt, from the list above select the
Passenger/Right side rear mounting bracket and secure it with factory Hex Bolt, Flat Washer,
Lock Washers (Fig 3) Shows bracket attached. Snug but do not tighten hardware at this time.
5. Select the Passenger/Right side sidebar and secure it to all mounting brackets with the (6)
10mm x 30mm hex bolts, (6) 10mm lock washer, and (6) 10mm flat washer. (Fig 4) shows side
bar attached to all brackets, Snug but do not tighten hardware at this time.
6. Level and align Sidebar properly; then tighten all hardware at this time.
7. Repeat steps 2-6 for Driver/left sidebar.
8. Do periodic inspections to the installation to make sure all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Product.
For gloss black finishes: Mild soap may be used to clean the Product.
FRONT PASSENGER SIDE
Fig 2 Fig 1
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
Fig 3
Passenger rear
Fig 4
Install mounting
bracket with
Factory body Bolt &
washer. Shown with
(6)10mm hex bolts
(6)10mm flat washers
(6)10mm lock washers
Page 2 of 3 10/4/2010)