Aries Automotive 207003-2 User Manual
Installation Instructions
2007-10 Hyundai Santa Fe
Part # 207003 / 207003-2
Step One: Locate Hardware kit. Check contents with hardware listed below.
NO. NAME QTY REMARKS NO. NAME QTY REMARKS
○1 SIDE BAR（LEFT） 1 ○
SIDE BAR（RIGHT）
○2
1 ○
11
12
HEX NUT 4 M12
T-BOLT C 2
M10×35
FRONT BRACKET（LEFT）
○3
1 ○
○4 FRONT BRACKET（RIGHT） 1
○5 REAR BRACKET（LEFT） 1
REAR BRACKET（RIGHT）
○6
○7 HEX BOLT 2
1
M12×35
13
HEX NUT 4 M10
○14SPRING WASHER 8 10mm
15
○
○
○
FLAT WASHER 12 10mm
16
17
HEX BOLT 4
HEX NUT 4 M10
M10×30
○8 FLAT WASHER 6 12mm ○18PLASTIC PIECE 4 M12
○9 SPRING WASHER 6 12mm ○
○10 T-BOLT A 4
PARTS PIC
○1 ○2 ○3 ○4 ○5 ○6
M12×35
19
T-BOLT B 2
M10×35
○7 ○8 ○9 ○10 ○11 ○12 ○13 ○14 ○15 ○16 ○17 ○18 ○19
Step Two: Remove the front body mount plastic covers(pic 1).
Step Three: Place the front bolt B plate through the body as shown in pic 2. Attach front
support bracket as shown in pic 2.
Page1 of 2
Installation Instructions
2007-10 Hyundai Santa Fe
Part # 207003 / 207003-2
PIC 1 PIC 2
Step Four: Place the rear bolt plate through the body as shown in pic 3. Attach rear
support bracket as shown in pic 4 .
PIC 3 PIC 4
Step Five: Loosely attach the side bars to the brackets(pic 5).
PIC 5
Step Six: After checking to make sure the side bars are level and parallel with the sides
of the vehicle completely tighten all hardware.
Step Seven: Repeat steps three, four , five ,six and seven on opposite side.
Step Eight: Periodically check and retighten the hardware as necessary.
Plastic covers Plastic covers
○14○15○16○17
Through
○7○8○9
Front bracket(right)
○13○14○15○19
○12○13○14○15
○8○9○10○11○18
Rear bracket(right)
Front Rear
Page2 of 2
Loading...