Aries Automotive 200008-2 User Manual
INSTALLATION INSTRUCTIONS
2006-08 GRAND VITARA
ATTENTION
λ Please read this installation Menu before installing this part. When install it, pay attention to
protecting your vehicles.
λ When use it, please check this parts at a fix time - lapse, such as one month or two month.
PART LIST
No. NAME QTY REMARKS No. NAME QTY REMARKS
1
SIDE STEP (Lef t .Side)
○
2
SIDE STEP (Right. Sidel)
○
3
FRONTBRACKET (Dr. Side)
○
FRONT BRACKET( Pass. Side)
4
○
REAR BRACKET(Dr. Side)
5
○
. REAR BRACKET(Pass. Side)
6
○
THREADED PLATE
7
○
HEX NUT
8
○
LOCK WASHER
1
1
1
1 10mm
PART # 200008 / 200008-2
FLAT WASHER 4 12mm
9
CAPSCREW
○
LOCK WASHER
1 M10×25×1.25
1
2
4 M12
4 12mm
FLAT WASHER
10 Threaded Bar
○
LOCK WASHER
FLAT WASHER
HEX NUT
4 M 8×25
4 8mm
4 8mm
8 M 10×40
8 10mm
8 10mm
8 M10
INSTALLATION STEPS
1. Insert Thread Plate # 7 inside chassis hole "A" on the passenger side so that its other
threaded bar would expose from chassis holes "B" according to Pic. No 1.
2. Place Front Bracket # 4 so that Thread Bar # 7 expenses through it. Screw with nuts # 8 & # 9.
Page 1 of 2
3. Place Rear Bracket # 6 on the chassis holes "C" on the passenger side and attach it with bolts
# 10.
4. Screw Thread Bar # 11 to the Side Step # 2.
5. Insert the Side Step # 2 by Thread Bar # 11 in the Brackets (# 4 & # 6) and screw with
washers and nuts.
6. Install Side Step # 1 on the driver side in the same way.
7. Adjust the Side Steps and tighten the bolts.
Note:It is recommendable to retighten all fixing bolts and nuts after the SideStep has been in use
for some 1000 km/600 miles.
○7
○8
○3
○1
○8
○4
○5
○2
○6
○9
○10
Picture for reference
Page 2 of 2
Loading...