Aries Automotive 15910 User Manual
INSTALLATION INSTRUCTIONS
2007-14 JK ROOF LIGHT BAR
PART # 15910
PARTS LIST:
Qty’s Description
1 Upper Base 10 8mm x 30mm Button Head Bolts
1 Driver/Side Pillar Bracket 2 8mm x 25mm Button Head Bolts
1 Passenger/Side Pillar Bracket 8 8mm x 16mm OD Flat Washers
1 5mm Allen Wrench 12 8mm Lock Washers
4 8mm x 24mm OD Flat Washers
Qty
’s
Description
Upper Base
Driver/Side Pillar bracket
Passenger/Side Pillar bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting on the Passenger/Right side of the vehicle at the bottom of the windshield pillar, there are (5)
factory Torx bolts securing the hinge of the windshield to the vehicle (3) on the side & (2) in the front
remove only one side
as seen in (Fig 1)
3. Once removed selected the Passengers/side pillar bracket from the list of parts above & begin to
install by attaching to vehicle with (3) 8mm x 30mm Button head bolts, (3) 8mm x 16mm OD flat
washers & (3) 8mm lock washers for the side as seen in (Fig 2) Snug but do not tighten hardware,
for the front of bracket secure with (2) 8mm x 30mm Button head bolts, (2) 8mm x 24mm OD flat
washers & (2) 8mm lock washers, as seen in (Fig 2A). Snug but do not tighten hardware
4. Once completed follow Step 2 -3 for the Driver side.
5. With both pillar mounting brackets installed to the vehicle select the Upper base from the list of
parts above and secure to the pillar brackets with (2) 8mm x 25mm Button head bolts, (2) 8mm x
16mm OD flat washers & (2) 8mm lock washers, as seen in (Fig 3 & 3A). Snug but do not tighten
hardware.
Page 1 of 2
6. Level and adjust the light bar, tighten all hardware, Install is now complete.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
Fig 1
Passenger/right side shown
Fig 2
Passenger/right side pillar bracket
Factory
Torx
bolts
removed
Secure to side pillar with
(3) 8mm x 30mmbutton head bolts
(3) 8mm x 16mm OD flat washers
(3) 8mm lock washers
Fig 2A
Fig 3
Secure to front with
(2) 8mm x 30mm button
head bolts
(2) 8mm x 24mm OD flat
washers
(2) 8mm lock washers
Secure to side pillar with
(1) 8mm x 25mm button head bolts
(1) 8mm x 16mm OD flat washers
(1) 8mm lock washers
Fig 3A
Secure to side pillar with
(1) 8mm x 25mm button head bolts
(1) 8mm x 16mm OD flat washers
(1) 8mm lock washers
Installation complete
Page 2 of 2
Loading...