Aries Automotive 1044-2 User Manual

INSTALLATION INSTRUCTIONS

GRILL GUARD PART#1044/1044-2

JEEP GRAND CHEROKEE 99-04

PARTS LIST

1-FRONT BAR 10-M12×35 HEX BOLTS

1-MOUNTING FRAME BRACKET (DRIVER SIDE) 20-φ12 FLAT WASHERS

1-MOUNTING FRAME BRACKET (PASSANGER SIDE) 6-Φ12 SELF APPING NUTS

10-M12 HEX NUTS

INSTALLING THE FRAME MOUNTING BRACKETS

STEP1: REMOVE FACTORY TOW HOOKS FROM FRONT SECTION OF VEHICLE (NOTE:DO NOT

THROW AWAY THE FACTORY BOLTS . THEN WILL BE REUSE TO ATTCH THE MOUNTING

BRACKETS).

STEP2: ALIGN DRIVER SIDE MOUNTING BRACKAT TO THE BOTTOM EDGE EXSTING HOLES

WHICH ATTACH THE HOOK.PISITION BRACKET IN MANNER SHOWN BELOW.

STEP3: ATTACH MOUNTING FRAME BRACKETS USING FACTORY BOLTS AND φ 12 FLAT

WASHERS..(HAND LIGHTEN AS YOU HAVE TO MOVE THE BRACKETS AROUND

SLIGHTLY,TO ALIGN THE FRONT BAR)

STEP4: REPEAT STEP2 AND STEP 3 TO INSTALL THE PASSENGER SIDE.

INSTALLING THE FRONT BAR

1. LINE UP THE THREE HOLES ON THE LOWER PORTION OF THE FRONT BAR WITH THREE

HOLES ON THE MOUNTING FRAME BRACKETS (INNEI EDGE) USINGTHE M12×35 HEX BOLTS,

M12 HEX NUTS ANDφ12 FLAT WASHERS TO FASTEN THE FRONT BAR TO THE MOUNTING

FRAME BRACKETS.ONCE THE FRONT BAR IS ATTACHED TO THE MOUTING BRACKETS, ALIGN

THE LELT AND RIGTH SIDE OF THE FRONT BAR TO THE BUMPER.

2. ONCE SATISFIED THAT LEFT AND RIGTH SIDE AER EQUAL DESTANCE FROM THE BUMPER

TIGHTEN ALL FASTENERS.

NOTE: IT IS ADVISABLE TO RE CHECK ALL FASTENERS FOR TIGHTNESSS AFTER ONE WEEK.

Page 1