Aria DMX1 User Manual

Copyright © 2015, ALL RIGHTS RESERVED

Aria Lights DMX Decoder User Guide

Model DMX1, Revision C

DMX Decoder User Guide www.arialights.com

Aria Lights DMX Decoder User Guide

Revision C

Introduction

The Aria Lights DMX1 Decoder is designed to allow up to 30 Aria Diva or Solo music stand

lights to be dimmed from a central lighting console. Lights can be dimmed in three separate

banks of ten. 256 dimming levels allow fine control over lighting conditions.

Warnings

• This device is not intended for operation in wet environments. Make sure that the

decoder box and all cables are free from moisture. Never operate in wet

conditions.

• Do not extend the cables more than six feet beyond their lengths.

• Do not use with any devices other than Aria Lights brand Diva and Solo LED music

stand lighting.

• Use only 120VAC power to supply the box. Excessive voltage will cause damage.

• Modifications to the hardware will void the warranty and could pose a fire hazard.

• Do not operate the decoder with the cover removed. High voltages are present

inside and could cause electrical shock.

• Do not exceed DMX voltages on the DMX inputs as damage may result.

• Do not use a dimmed outlet to power the decoder or damage may result. A steady

120VAC power source is to be used.

• Do not use more than 30 lights on a single decoder.

• Do not attempt to create “Y” connections to add additional lights.

• Ensure that all cables are free from damage and not pinched before operating.

• If cables are damaged, discontinue use at once.

• Keep the decoder cool and free from obstructed air flow or damage may result.

The cabinet is used to dissipate heat. Do not operate without rubber feet.

3

DMX Decoder User Guide www.arialights.com

Connecting the Decoder to Music Stand Lights

Insert one to three of the 35-foot music stand light cables in the back of the decoder. Twist

the connector clockwise to lock it onto the controller. You should feel a click when the cable

is locked. Turn the connector counterclockwise to disconnect.

Each cable serves up to ten stand lights and occupies one DMX address or one bank. There

are three DMX addresses and three cables per decoder. The left connector, bank 1,

corresponds with the primary DMX address (as configured by the DIP switches). The center

connector, bank 2, is the primary address plus one. The right connector, bank 3, is the

primary address plus two.

Connect the barrel connectors on the other end of the cable to your music stand lights.

Cord extenders are available if your cables do not reach. One six-foot cord extender may be

used on each light. Additional cord extenders will drop the voltage and may produce a

dimmer light and are therefore not recommended.