Westbury - Entertainment Unit
Assembly Instructions- Please keep for further reference 404/2208
391/0719
411/7786
Dimensions
Width - 130.4cm
Depth - 42.2cm
Height - 63cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6403030
BK04830 - Issue 1 - 20/03/2015
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• Due to difference in floor
levels, doors may not be
aligned. Adjustment may be
necessary.
• Do not use extended drawers
to aid standing. Do not stand on
extended drawers.
• Do not over load drawers,
the maximum load per drawer
should not exceed 3kg
• To prevent bowing of shelves
do not over load, and always
distribute weight evenly.
• If a residual aroma is
experienced with your new
furniture after the packaging
is removed simply ensure the
room is well ventilated and this
will assist a speedy removal
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• It is essential that this unit be
fixed to a wall with the fittings
provided.
• Please retain the product label
on the back of the unit, as this
information will help support any
queries.
Care and maintenance - Non compliance with this information may affect your guarantee
• Dust with a clean cloth or, if
required a slightly damp cool
cloth. Do not use household
cleaners, abrasives or polishes
as permanent damage may
occur.
• Do not drag the furniture or lift
it by its top.
• Avoid sharp objects, contact
with water and direct heat on all
surfaces
• Your furniture is finished to the
required colour. Avoid exposure
to strong sunlight as this can
change the colour. Change in
appearence may also occur if
items are permanently left on a
surface.
• You should get assistance
when moving or lifting your
furniture. Furniture consisting of
more than one unit should be
disassembled before attempting
to move it.
• Doors and drawers should
be secured or removed before
moving.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all boths and fittings are
tightened properly.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
1
If you have damaged or missing components, call the
Components - Panels
Customer Helpline:
Please check you have all the panels listed below
0345 6403030
Entertainment unit
1
(63 x 130.4 x 42.5cm)
2
Components - Fittings
Please check you have all the fi ttings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fi ttings
may be supplied than are required.
A
B C
15mm Screw x 1 15mm Washer x 2
The following components are pre-fi tted and are illustrated for reference only.
Knob handle x 2
20mm Handle screw x 2
Tools required
Phillips screwdriver
(medium)
Wall strap x 1
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50
The screws length is measured from the head to the point (30mm screw shown) .
3
55 60
65 70 75 80
85 90 95 100
105
110 115 120 125 130 135 140 145 150
155 160
165 170
Assembly Instructions
Step 1
Remove and replace
handles
a: Position the unit in
the required position.
The Knob handles are
fi tted to the inside of
the unit, using a Philips
screwdriver unscrew the
20mm handle screws in
each handle and remove
both the 20mm handle
screw and the knob
handles.
a:
Philips screwdriver
20mm Handle screw
1
b: Replace the knob
handle on the front of
the unit. Fix in position
by screwing the 20mm
handle screw into each
knob handle from inside
the unit using a Philips
screwdriver.
Note: Only use the
20mm handle screw that
the handles were prefi tted with.
b:
1
1
Philips screwdriver
20mm Handle screw
Knob handle
4
Assembly Instructions
Step 2
Fixing to wall
It is recommended that
the unit is fi xed to a wall
Fix wall strap
C
to the
back of the unit using
A
15mm screw
15mm washer
and
B
.
Warning: The 15mm
A
screw
is for
fi xing the wall
C
strap
to
furniture only. In addition
to this you will need to
choose a screw or fi tting
which is suitable for
securing the wall strap
C
to the type of walls you
have. If you are unsure
about what type of screw
to use seek professional
help.
Unit Top
B
A
Using the correct type of
C
screw, screw through the
washer and wall strap
into a pre-drilled hole in
the wall
Assembly is Complete.
5
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 6403030
If you need help or have damaged or missing parts, call the Customer Helpline: 0845 2417621
Loading...