Argos K09F1062C, SW9F1062C ASSEMBLY INSTRUCTIONS
KEEP THESE INSTRUCTIONS FOR FURTHER USE
MORF NOITAMROFNI GNIWOLLOF EHT ETELPMOC
THE
MODEL THICKNESS TYPE CLASS
GLASS NOMINAL
DOOR .............................................................................................
MIRROR .........................................................................................
SHELF ............................................................................................
TABLE TOP ....................................................................................
COMPLIES WITH B.S. 6206 DATE .........................................
WARNINGS
Do not place very hot or very cold items against or in close proximity
to glass surfaces unless an adequately thick insulating material is
used to prevent such items from coming into contact with glass.
Do not strike glass with hard or pointed items.
When cleaning glass panels or mirrors use a damp cloth or leather
with washing up liquid or soft soap if necessary; do not use washing powders or any substances containing abrasives since these
substances scratch glass.
Maximum evenly distributed safe load per glass shelf not to exceed
15kg.
1.
2.
3.
4.
If a glass component is chipped or broken replace the glass of the type
described on the label. Consult the manufacturer, retailer or agent with
regard to obtaining a manufacturing specification and shape for replacement glass quoting the model number and date of manufacture.
SHOULD YOU REQUIRE ANY ASSISTANCE WITH YOUR UNIT
YOU CAN CONTACT CUSTOMER SERVICES ON 01482 701173
Cornice
Assembly Instructions
Important! Please note, This cornice must
be firmly fixed to the carcass as instructed,
with the provided screws. Failure to do so
could result in the cornice falling off the unit
causing injury.
To Assemble this fitment you will need a posi-drive
screw driver, a hammer, a step ladder (or equivalent),
and one other person to assist.
Cornice Joint Assembly
1
Fitting The Cornice
2
Place the cornice on top of the robe, you may
need to use step ladders to do this. Position the
cornice being careful to ensure that the back edges
of the cornice are flush with the back of the robe
and that the overhang on each side is equal. Once
the position is correct, screw down firmly with
a posi-drive screwdriver using the screws provided.
It may not be necessary to use all the screws in
the pack
Work on a clean, flat and firm surface.
Position a side cornice rail (one angled end)
and a front cornice rail (twin angled ends) together
to make a corner. Press the Plastic dovetail jointer
into the grooves in the cornice
Plastic Dovetail jointer
Cornice
Tap home firmly with a hammer to make the
joint tight. Repeat for the other corner
Cornice
Cornice Sizes
The cornice is fixed in the same way for a double
robe, three door run and a four door run.
Code: ST71500
Issue 4: 04/05/06
Loading...