Romantic Nest of 2 Tables
Assembly Instructions - Please keep for future reference 651/8486
Dimensions
Large Table :
Width - 54.5cm
Depth - 36cm
Height - 46.7cm
Small Table:
Width - 38.5cm
Depth - 31cm
Height - 39.4cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Issue 1 - Nov/20/16
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• From time to time check that
there are no loose screws on
this unit.
• Regularly check and ensure
tightend properly.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
1
If you have damaged or missing components, call the
Components - Panels
Customer Helpline:
Please check you have all the panels listed below
Table Top (54.5 x 36cm)
1
Argos = 0345 6400800
Back Legs x 2 (44.2 x 4cm)
2
Left leg (44.2 x 4cm)
3
Short stretcher x 2 (24 x 6cm)
5
Table Top (38.5 x 31cm)
7
Right leg (44.2 x 4cm)
4
Long stretcher (41.7 x 6cm)
6
Back Legs x 2 (36.9 x 4cm)
8
Left leg (36.9 x 4cm)
9
Short stretcher x 2 (19.4 x 6cm)
11
Right Leg (36.9 x 4cm)
10
Long stretcher (25.7 x 6cm)
12
2
Components - Fittings
105
Note:
may be supplied than are required.
A
35mm Screw x 12 Allen key x 1
D
16mm Flat washer x 16
B
50mm Bolts x 16
E
10mm Spring washer x 16
C
F
20mm Pads x 8
Tools required
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
The screws length is measured from the head to the point (30mm screw shown).
110 115 120 125 130 135 140 145 150 155 160 165 170
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Ruler/tape
measure
3
Assembly Instructions
Step 1
Attaching legs & strecher
a: Position short stretcher
5
into hole in back leg
2
and Right leg
Fix though holes shown
using screws
4
A
.
b: Position short stretcher
5
into hole in back leg
2
and Left leg
Fix through holes shown
using screws
3
A
.
a:
b:
A
4
A
5
3
5
2
c:
Position long stretcher
6 into hole in back leg
2
Fix through holes shown
using screws
A
c:
2
3
4
2
A
2
6
4
Assembly Instructions
Step 2
a: Assembly Leg & Top
Attached the assembled
unit to the table top
Using bolt , spring
washer and flat washer
tightened with allen
D
key .
B
E
C
1
Wrong
a:
Long Strecher 6
Note: Put group legs to
Table Top with long stretcher
direction at back the Table Top
Back Table Top
b: Attach the pad
Remove cover paper on the
F
pad . Attach the pad
into under the legs.
With help stand the large
table upright.
b:
Long Strecher 6
D
B
E
1
F
Back Table Top
F
B
C
Remove
F
5
Assembly Instructions
Step 3
Attaching legs & strecher
a: Position short stretcher
into hole in back leg
11
8
and Right leg
Fix through holes shown
using screws
10
A
.
b: Position short stretcher
11
into hole in back leg
8
and Left leg
Fix through holes shown
using screws
9
A
.
a:
b:
A
10
A
11
9
11
8
c:
Position long stretcher
12 into hole in back leg
8
Fix through holes shown
using screws
A
c:
10
8
9
A
8
12
8
6
Assembly Instructions
Step 4
a: Assembly Leg & Top
Position the group Legs
& stretcher to Table Top
7
. Using Bolts
Spring washer and
Flat washer
B
E
D
Wrong
a:
Long Stretcher 12
Note: Put group legs to
Table Top with long stretcher
direction at back the Table Top
Back Table Top
b: Attach the pad
Remove cover paper on the
F
pad . Attach the pad
into under the legs.
With help stand the small
table upright.
b:
Long Stretcher 12
D
B
E
Back Table Top
7
F
F
B
C
Remove
F
7
Loading...