
Triple Metal And Polycotton Wardrobe
Assembly lnstructions - Please keep for future reference 343/6004
356/0970
Dimensions
Width - 147cm
Depth - 54cm
Height - 175cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts,call the
Customer helpline
:
0345 6400800
Issue 1-11/03/14

!
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Assemble the unit as close to its
components and tools listed on
page 2.
final position (in the same room)
as possible.
Warning
:
plastic bags and separate them into
their groups.
space to layout the parts before
starting
could cause damage.
Care and maintenance
bleach or abrasive cleaners. unit.
Assemble on a soft level surface
to avoid damaging the unit or your
floor.
e tools.
We do not
recommend the use
of po
for inserting screws,
as this could damage the unit.
cables.
and responsibly.
Warning
Short hanging rail - 10 kg
Long hanging rail - 15 kg
This product should not be
disposal centre.
:
1

If you need help or have damaged or missing
Components - Parts
parts,call the
Please check you have all the parts listed below
Customer helpline
:0345 6400800
1 Shelf x 1(67.5x53.4cm) 4 Thin rods x 2(82.4cm)
5 Thin rods x 2(86.4cm)
9 Connector x 4
15 Thin rods x 1(69cm) 16 Thin rods x 1(42.5cm)
14 Cover x 1
18 Thin rods x 2(87.7cm)
2 Shelf x 2(40x54cm)
6 Thin rods x 24(28.2cm) 7 Thin rods x 3(67.5cm)
11 T-Connector x 2pcs
hole
19 Shelf x 1(40x54cm)
3 Thin rods x 5(50cm)
12 Hook x 410 Hook x 1
locking pin
20 Thin rods x 5(35.8cm)
8 Corner x4
13 Shelf x 4(40x54cm)
17 Thin rods x 2(87.7cm)
Components - Fittings
Please check you have all the parts listed below
Note: The quantities below are correct amount to complete the assembly.
In some cases more fittings may be supplied than required
A B
2x)ylno sllaw dilos rof( gulp llaW2 x wercS
Tools required
MEASURE
Tape Measure
2

Assembly Instructions
Step 1
Note:It would be useful
to ask someone to help
you at this stage.
a: Attach shelf into
shelf as shown
2
1
in the figure.
Note: Make sure the
shelf panel with yellow
dot face upwards
!
b: Insert vertical rods
6 2
into shelf as
shown.
a:
b:
2
1
2
!
6
6
1
6
2
6
2
c: Attach shelf
to vertical rods
13
6
Then insert vertical rods
6
and repeat for other
13
shelf .
3
c:
13
13
6
6
6
6
2
1
2
6
6

Assembly Instructions
Step 2
a: Attach thin rods
and to shelf
18
4
2
as shown in the figure.
b: Insert thin rods
into T-connector
3
11
Attach assembled thin
rods to thin rods .
3
4
a:
b:
18
18
4
2
18
13
13
2
11
6
6
6
1
3
4
11
6
c: Attach thin rods
16 10
and and hook .
15
Then insert the
assembled unit into
shelf .
19
c:
13
13
19
3
18
4
4
15
10
19
16
15
10
4

Assembly Instructions
Step 3
a: Attach assembled
shelf to thin rod
19
and thin rods as
shown
in the figure.
3
Then repeat step1c for
the other two shelves
assembly.
b: Insert thin rods
T-connector
11
insert thin rods
18
thin rods
as shown
in the figure.
5
and
17
to
6
to
13
a:
b:
6
13
13
13
13
19
6
6
18
15
6
6
3
17
18
5
17
4
4
5
6
c: Insert thin rods ,
, to connector
7
20
8 9
and as shown
3
in the figure.
c:
20
15
4
20
7
3
3
3
9
20
8
7
18
3
20
5

Assembly Instructions
Step 4
a: Attach assembled top
frame to thin rod and
thin rods as shown
5 17
6
in the figure.
b: Insert thin rods
7
and into hook
.
12
20
a:
b:
12
17
6
6
20
5
7
12
17
5
12
c: Attach assembled
hanging rod to thin
rods as shown in
3
the figure.
12
3
3
3
c:
6

Assembly Instructions
Step 5
a: Fitting the cover
into assembled frame
as shown in the figure.
Note: It is recommended that two people
fit the cover to the
frame.
14
a:
14
b: Fasten the ties at
bottom.
b:
7

Assembly Instructions
Step 5
Fixing to wall
It is recommended that
the wardrobe is fixed to
a wall.
Note:
The correct type of fixing
must be used for your
wall,seek professional
advice if doubt.
Mark the fixing hole on
the wall and remove the
wardrobe. Drill a hole and
insert a wall plug .
Warning:
!
Before drilling,
check the wall for
hidden pipes and
cables.
B
A
Top panel
B
wall
Reposition the wardrobe
and fix the wall strap
using screw .
The assembly is now
complete.
A
If you need help or have damaged or missing parts,call the Customer helpline: 0345 6400800
8