JAMAL NEST OF TABLES
Assembly Instructions - Please keep for future reference
609/7079
609/7086
Dimensions
Width - 48cm
Depth - 40cm
Height - 46cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
issue 2 12/08 /’1 6
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2 and 3.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Do not stand on the panels, this
could cause damage.
Assemble the unit as close to its
final position (in the same room)
as possible.
Assemble on a soft level
surface to avoid damaging the unit
or your floor.
Parts of the assembly will be
easier with 2 people.
●From time to time check that
there are no loose screws on this
unit.
We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit. Only use hand
screwdrivers.
Dispose of all packaging carefully
and responsibly.
Warning: The unit weighs
approximately 15.5kgs.
Please lift with care.
●This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
1
Components - Panels
If you have damaged or missing components,
call the Customer Helpline:08456 400800
Please check you have all the panels listed below
Top L (48 x 40cm)
1
Side L x 2 (40 x 39.8cm)
2
Top M(34 x 34cm)
3
Side M x 2 (32x 33.8cm)
4
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
Threaded bolt x 8
D
Washer x 8
G
Wrench x 1
B C
Dowel x 8
E
Spring washer x8
H
Cover cap x 8
Spacer x 8
F
Screw nut x 8
Foot pad x 8
Tools required
Long-nose pliers
2
Assembly Instructions
Step 1
Step 1
Fitting bolts and dowels
A
a:
a: Screw in Threaded
bolt onto Top .
A
1
A
1
b: Insert Dowels into
Sides .
3
2
B
b:
b:
B
2
2
B
Assembly Instructions
Step 2
Fitting the side panel
a: Use Spacers ,
Washers ,Spring
washers ,Screw nuts
and Wrench to fix
Sides onto Top .
D
E F
2
Note: A Long-nose
pliers is required to fully
tighten the Screw nuts .
C
G
1
F
a:
F
E
D
G
C
2
2
I
b: Use Cover caps to
cover the holes on
Sides,Stick Foot pad
onto the unit.
Note:
Step 2 to assemble the
small table using Top
and Side .
Assembly is complete.
Repeat Step 1 and
4
H
I
3
b:
II
1
I
2
H
2
If you need help or have damaged or missing parts, call the
Customer Helpline : 08456 400800
4
Loading...