Argos EV-025BK-12 ASSEMBLY INSTRUCTIONS
Verona Corner TV Unit
Assembly Instructions - Please keep for future reference
609/5057
610/3475
Dimensions
Width - 60cm
Depth - 40cm
Height - 59.5cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
issue 1 4/28/10
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2 and 3.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Do not stand on the panels, this
could cause damage.
Assemble the unit as close to its
final position (in the same room)
as possible.
Assemble on a soft level
surface to avoid damaging the unit
or your floor.
Parts of the assembly will be
easier with 2 people.
●From time to time check that
there are no loose screws on this
unit.
We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit. Only use hand
screwdrivers.
Dispose of all packaging carefully
and responsibly.
Warning: The unit weighs
approximately 11kgs.
Please lift with care.
●This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
1
Components - Panels
Please check you have all the panels listed below
3
Back panel (57.5 x 20cm)
1
Table top (60 x 40cm)
Leg x 6 (19.3 x Ø3.5cm)
4
If you have damaged or missing components,
call the Customer Helpline:08456 400800
Foot x 2 (4.7 x 3.4cm)Ø
2
Shelf x 3 (60 x 38.5cm)
5
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
Cap screw x 2
Pre-assembled at 5
D
50mm Screw x 6
Tools required
Phillips screwdriver
(medium & large)
B
B
Locking pin x 2
Locking pin x 2
E
Tool x 1
C
Locking nut x 2
Ruler/tape
measure
Flatblade screwdriver
(medium)
Ruler - Use this ruler to help correctly identify the screws
105
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
2
Loading...