Argos 6069447, 6187202, 6221168 ASSEMBLY INSTRUCTIONS

New Pagnell Desk
Assembly Instructions -
Please keep for future reference
622/1168
618/7202
606/9447
Dimensions
Width - 100cm
Depth - 48.5cm
Height - 71.5cm
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Version 1 Date: 09/11/16
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on the following pages.
• Remove all fi ttings from the plastic bags and separate them into their groups.
• Keep children and animals away from the work area, small parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before starting.
• Do not use this item if any
components are missing or damaged.
• During assembly do not stand or put weight on the product,
this could cause damage.
Assemble the item as close to its fi nal position (in the same room) as possible.
Assemble on a soft level surface to avoid damaging the unit or your fl oor.
• During assembly children should be kept away from the product due to possible risk of
injury.
• Parts of the assembly will be
easier with 2 people.
power drill is set on a low torque setting.
Glue safety - Take care when using glue, please follow the advice below
Skin contact: Remove
contamination by washing with soap and water. This procedure should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
To reduce the likelihood of
damaging your product please ensure that your
Care and maintenance
• Only clean using a damp cloth and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that there are no loose screws on this unit.
This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Handy Hints
Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts
• Regularly check and ensure that all bolts and fi ttings are tightend properly.
IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
• Argos Ltd. MK9 2 NW. • This product is intended for
children in the age 6 or above.
• Maximum load: 50 kgs (top of desk).
• Assembly of this product must
be carried out by a competent adult.
Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with these instructions for future reference.
1
If you have damaged or missing components, call the
Components - Panels
Customer Helpline:
Please check you have all the panels listed below
Argos = 0345 6400800
Table top (100 x 48cm)
1
Right side panel
4
(46 x 70cm)
Pilot holes for guidance only
Middle panel
5
(46 x 70cm)
Top support
2
Finished front edge
Bottom support
3
(58.5 x 11cm)
(58.5 x 11cm)
Left side panel
6
(46 x 70cm)
Front support
7
(36.7 x 11cm)
Back support
8
(36.7 x 11cm)
Front panel
9
(36.7 x 4.5cm)
Drawer front x 2
10
(36 x 14.4cm)
Drawer right side
11
x 2
(34 x 11.5cm)
Drawer left side
12
x 2
(34 x 11.5cm)
Drawer back
13
x 2
(33.5 x 11.5cm)
Drawer bottom
14
(33.6 x 34.4cm)
x 3
Large drawer
15
front
(36 x 33.6cm)
Large drawer right
16
side
(34 x 24cm)
Large drawer left
17
side
(34 x 24cm)
Large drawer back
18
(33.5 x 24cm)
Back panel
19
(60 x 39.4cm)
2
Components - Fittings
Note:
The quantities below are the correct amount to complete the assembly. In some cases mor
may be supplied than are required.
A
Runner x 6
D
Plastic support x 2
G
15mm Locking nut x 10
J
Nail x 12
M
30mm Screw x 12
B
(This Screw is included in the bag of runner)
12mm Screw x 18
E
14mm Screw x 4
H
50mm Screw x 8
K
12mm Locking nut x 12
N
12mm Screw x 6
C
30mm Dowel x 13
F
39mm Locking pin x 22
I
Screw cover x 4
L
Glue x 1
Tools required
Phillips screwdriver (medium & large)
Flatblade screwdriver (medium)
Drill
7mm Suitable drill bit (for use with wall plug)
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
The screws length is measured from the head to the point (30mm screw shown).
3
105
Small hammer
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Ruler/tape measure
Eye protection (when using a hammer or glue)
110 115 120 125 130 135 140 145 150 155 160 165 170
Assembly Instructions
Step 1
Attaching runners
a:
Position Runners in
A
front edge of the Right side panel .
4
Slide top of the Runners
A
Runners on the
side panel .
.
B
A
4
Right
a:
4
A
Middle hole
A
A
A
B
B
1.7cm
B
Note:
The front part of the runner should be approximately 1.7cm from the front edge of the panel.
b:
Slide top of Runners
A
forward and x as shown using Screws .
Insert Dowels into the
C
Right side panel .
Screw Locking pins
B
4
F
into the Right side panel
.
4
b:
B
4
Finished front edge
Middle hole
B
A
Pilot holes for runner position
B
F
4
Note:
Insert locking pins
as far as shown.
Do not over tighten.
Continued on next page.
B
F
B
B
B
F
B
4
C
B
C
C
4
Loading...
+ 10 hidden pages