Page 1
Verona Telephone Table
Assembly Instructions - Please keep for future reference
609/5071
609/1226
Dimensions
Width - 34cm
Depth - 30cm
Height - 59cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
issue 1 4/28/10
Page 2
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2 and 3.
Remove all fittings from the
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
Do not stand on the panels, this
could cause damage.
Assemble the unit as close to its
final position (in the same room)
as possible.
Assemble on a soft level
surface to avoid damaging the unit
or your floor.
Parts of the assembly will be
easier with 2 people.
●From time to time check that
there are no loose screws on this
unit.
We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit. Only use hand
screwdrivers.
Dispose of all packaging carefully
and responsibly.
Warning: The unit weighs
approximately 2.6kgs.
Please lift with care.
●This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
1
Page 3
Components - Panels
Please check you have all the panels listed below
Shelf x 2 (34 x 30cm)
1
If you have damaged or missing components,
call the Customer Helpline:08456 400800
Post x 4 (55.3 x Ø3.5cm)
2
Foot x 4 (4.7 x 3.4cm)Ø
3
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
Cap screw x 4
Pre-assembled at 3
2
Page 4
Assembly Instructions
Step 1
Step 1
Fitting the feet
a: Unscrew Cap screws
A 3
a from the Feet .
a:
A
3
b: Insert Feet into the
Shelf .
1
3
b:
1
3
3
Page 5
Assembly Instructions
Step 2
Fitting the shelf
a: Screw Posts into
the Feet .
3
2
a:
2
3
b: Carefully locate the
Shelf onto the unit.
1
b:
1
4
Page 6
Assembly Instructions
Step 3
Fitting the cap screws
A
1
Screw in Cap screws
to fix the Shelf onto
the unit.
A
1
Step 4
Finishing the unit
Carefully place the unit in
the desired location.
Note: Before use always
make sure the unit is
secure.
Assembly is complete.
If you need help or have damaged or missing parts, call the
5
Customer Helpline : 08456 400800
Loading...