
Modular TV Unit
Assembly Instructions
-
Please keep for future reference
609/2256
609/2263
609/2270
609/2287
609/2294
609/3516
609/3602
327/9869
Dimensions
Width - 103cm
Depth - 50cm
Height - 46cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Version 3 Date: 24/09/14

Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fi ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its fi nal position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your fl oor.
• Parts of the assembly will be
easier with 2 people.
• From time to time check that
there are no loose screws on
this unit.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fi ttings are
tightend properly.
1

If you have damaged or missing components, call the
Components - Panels
Customer Helpline:
Please check you have all the panels listed below
back edge
Argos = 0345 6400800
Top panel
1
2
Middle shelf (99.8 x 35.9cm)
3
(99.8 x 49.8 cm)
Pilot holes for guidance only
(99.8 x 35.9cm)
Side panel x 2
6
(49.9 x 46cm)
Lower central panel
Bottom panel
7
(35.9 x 20.9cm)
Upper central panel
8
(35.9 x 14.5cm)
Back panel (99.8 x 29.5cm)
4
Pilot holes for guidance only
5
(99.8 x 5.9cm)
Front panel
2

sgnittiF - stnenopmoC
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
A
D
G
20mm Screw x 8
B
C
14mm Screw x 8 50mm Dowel x 2Plastic support x 4
E
F
30mm Dowel x 250mm Screw x 16 Screw cover x 14
Tools required
Phillips screwdriver
(medium & large)
7mm Suitable drill bit
(for use with wall plug)
Drill
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
The screws length is measured from the head to the point (30mm screw shown).
3
105
Small
hammer
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
110 115 120 125 130 135 140 145 150 155 160 165 170

Assembly Instructions
Step 1
a:
Attaching front panel
B
a:
the Plastic supports
onto the Front panel .
Position the Front panel
b:
5
onto the Bottom panel
using Screws .
2
B
A
5
B
b:
B
B
A
A
5
B
B
5
2
B
B
A
A
B
B
B
A
Step 2
Attaching middle shelf
Use Dowels into the
Upper central panel .
Position
panel and Lower central
panel onto the Middle
shelf using Dowels .
Two persons assembly
is required.
E
8
8
7
3
C
back surface
E
E
8
back edge
C
3
C
7
E
C
3
back surface
4

Assembly Instructions
Step 3
Attaching bottom
panel
Top
Position the Bottom panel
2
onto the Lower central
panel using Screws .
7
D
Two persons assembly
is required.
Step
4
back edge
7
D
2
Bottom
D
Attaching side panels
Position the Side panels
6
onto the unit using Screws
.
D
Use Screw covers to
F
cover the screw heads.
Two persons assembly
is required.
F
F
6
D
F
D
back edge
6
D
D
F
D
F
D
F
5

Assembly Instructions
Step 5
Attaching top panel
With help, carefully
a:
stand TV unit upright.
Warning:
The TV unit is
heavy.
Lift with care.
Position the Top panel
onto the unit.
a:
1
back edge
1
Use Screws to x Top
b:
panel onto the unit.
Use Screw covers to
cover the screw heads.
1
D
F
b:
F
F
F
D
D
D
1
D
D
D
F
F
F
6

Assembly Instructions
Step 6
Fixing back panel
Back panel onto the
unit.
Step 7
Finishing the unit
G
4
G
G
G
G
G
4
G
G
G
back surface
Note:
It would be useful
to ask someone to help
you at the stage.
With help, place the unit in
the intended position.
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
7