Argos 609/2139, 609/0131, 609/3554, 610/9534, 875/0383 Assembly Instructions Manual
...
Tall Wide & Extra Deep Bookcase
Assembly Instructions
-
Please keep for future reference
609/0117
Dimensions
Depth - 29.1cm
Width - 78cm
Height - 180.1cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the
Customer Helpline: 08456 400800
Ref. no. 609/0117,609/0131,609/1020,609/2043,609/2139,609/3554,610/9534 Version 2 Date: 25/05/10
609/0131
609/1020
609/2043
609/2139
609/3554
610/9534
Glue safety - Take care when using glue, please follow the advice below
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Care and maintenance
• Check you have all the
components and tools listed on
pages 2 and 3.
rom the
plastic bags and separate them
into their groups.
• Keep children and animals away
from the work area, small parts
could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand on the product,
this could cause damage.
• Assemble the item as close to
room) as possible.
• Assemble on a soft level surface
to avoid damaging the unit or your
r.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Note: Only apply the glue once
you are sure of the assembly.
Skin contact: Remove
contamination by washing with
soap and water. This procedure
should also be followed prior to
eating and drinking.
Eye contact: Rinse immediately
with clean water for 15 minutes
and seek medical advice.
If swallowed: Seek medical
advice immediately.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
1
2
Components - Panels
Please check you have all the panels listed below
Fixed panel x 2 (74.9 x 28.4cm)
1
Bottom panel
(74.9 x 28.4cm)
2
Left side panel
(180 x 28.6cm)
6
Shelf x 4
(74.9 x 28.4cm)
3
Top back panel
(79.8 x 76.7cm)
7
Bottom back panel
(93.6 x 76.7cm)
8
Right side panel
(180 x 28.6cm)
5
Front panel
(74.9 x 5.9cm)
4
If you have damaged or missing components,
call the Customer Helpline: 08456 400800
Finished front edge
Finished front edge
pilot holes for
guidance only
pilot holes for
guidance only
3
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
Components - Fittings
110 120 130 140 1500 10 20 30 40 50 60 70 80 90 100
0 1 2 3 4 5 6
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
105
110 115 120 125 130 135 140 145 150 155 160 165 170
Tools required
Phillips screwdriver
(medium & large)
Bradawl
(or sharp point)
Small
hammer
Ruler/tape
measure
Eye protection
(when using a
hammer or glue)
Ruler - Use this ruler to help correctly identify the screws
A
D
50mm Screw x 12
Wall plug x 1
Plastic support x 4
G
Wooden dowel x 6
J
B
E
14mm Screw x 9
Nail guide x 1
Support cover x 16
Screw cover x 12
H
K
C
F
I
Shelf support x 16
Wall strap x 1
Glue x 1
Nail x 46
L
(This screw is
included in the
bag of wall strap)
x 1
4
Assembly Instructions
Step 1
Step 2
a:
A
back edge
D
Attaching side panels
B
Finished
front edge
Finished
front edge
D
A
B
A
B
A
B
B
B
B
B
b:
D
D
D
D
D
D
D
D
D
G
G
G
G
Attaching bottom panel
a:
Use Plastic supports
Front panel onto the
Bottom panel .
A
2
4
B
Left Side panel and
Right side panel onto
the Bottom panel and
Fixed panels .
5
6
2
1
2
4
1
2
1
1
2
5
6
b:
Place a small amount of
Glue into the dowel
holes of the Bottom panel
and Fixed panels .
L
2
1
Then insert Wooden
dowels into the Bottom
panel and Fixed panels
.
G
2
1
G
L
Place a small amount of
Glue onto the joint’s
Wooden dowels .
L
G
G
Caution: Always
check the
assembly method
is correct before
applying glue.
5
Assembly Instructions
Step 3
a:
Fixing back panels
Top Back panel and
Bottom Back panel
onto the unit.
Note: Use Nail guide to
keep a constant distance
from the edge.
I
K
a:
7
8
8
7
K
I
Important:
The cabinet MUST
be ‘square’ when
the back is attached.
Loading...