Argos 603-6432, 603-6449, 603-6456 ASSEMBLY INSTRUCTIONS
Assembly Instructions
After the sitting test,
c:
re - tighten bolts again,
if any adjustment needed.
c:
Ascot Chair
Assembly Instructions - Please keep for future reference
603/6432
603/6449
603/6456
d:
It is highly recommend
to re - tighten all the bolts
again after using the chair
for 7 days.
Note : Please keep the
allen key to re - tighten
all bolts again when
required.
Assembly is complete.
d:
Dimensions
Width - 46cm
Depth - 52cm
Height - 96cm
If you need help or have damaged or missing parts, call the Customer Helpline: 0845 6400800
7
Important
If you need help or have damaged or missing parts, call the
– Please read these instructions fully before starting assembly
Customer Helpline: 08456 400800
Issue 1 - 9/02/10
Safety and Care Advice
Assembly Instructions
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
page 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product during assembly,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Maximum safe weight of
user: 110 Kgs.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Screw the lock seats
e:
D
with hand screw driver
by following the pre drilled
holes.
E
e:
E
Pre-drilled
hole
D
Step 2
Note : Stand the chair on
a level floor.
a:
Tighten all bolts.
b:
Sit on the chair to
the legs.
a:
b:
1
6
Assembly Instructions
c:
Stand the chair on a
floor. Insert bolts with
spring washers and
washers through side
C
rails holes into front leg
frame screw all bolts
3
by using ball allenkey .
A
B
G
c:
If you have damaged or missing components,
Components - Parts
call the
Customer Helpline: 08456 400800
Please check you have all the parts listed below
A
d:
Place the seat pad
2
on the table. Put the
chair frame on top of the
seat back.
d:
B
C
KCAB
5
3
7
1
2
Chair back x 1
4
6
1
3
F
Seat x 1
4
BACK
Right side rail x 1 Front leg frame x 1
Insert screw into
F
the pre - drilled holes on
the righ leg rail and
left leg rail using a
7
screwdriver.
5
7
6
6
1
2
6
BACK
5
Left side rail x 1
6
Right leg rail x 1
7
Left leg rail x 1
2
Loading...