Page 1
Executive Gas Lift Bar Stool
Assembly Instructions - Please keep for future reference 600/0372
600/1522
239/6011
Dimensions
Width - 51cm
Depth - 51cm
Height - 87.5-107.5cm
Important
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800
- Please read these instructions fully before starting assembly
Issue 1 - 28/04/14
Page 2
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Parts of the assembly will be
easier with 2 people.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Do not stand on the stool.
• Do not use this stool as step
ladder.
• From time to time check that
there are no loose screws on
this unit.
• To reduce the
likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Unit weight: 7.68 kgs.
• Maximum safe weight of user:
110kgs.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
1
Page 3
If you have damaged or missing components, call the
Components - Parts
Customer Helpline: Argos = 0345 640 0800
Please check you have all the parts listed below
Seat
1 Upper leg
(51 x 44.5 x 36cm)
2 Gas lift
(29.5 x 21.5 x 40.5cm)
3
(Ø5 x 46-67cm)
4
Decor ring
(Ø7.5 x 2cm)
5
Base
(Ø50 x 9.3cm)
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
M6 x 16mm Bolt x 4
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
B C
Washer x 4
105
110 115 120 125 130 135 140 145 150 155 160 165 170
Allen key x 1
2
Page 4
Assembly Instructions
Step 1
Attaching upper leg
Place the seat upside
1
down on a raised, flat
and protected surface.
Position the upper leg
2
and make sure that the
lever is at your right hand
side as shown in the
diagram.
Secure using bolts and
A
tighten bolts using allen
B
key .
A
B
2
A
B
A
B
1
A
A
B
B
Lever
1
2
Step 2
Attaching gas lift
Place the base on a
flat protected surface.
Position the decor ring
on the base and insert
the gas lift into the
decor ring and hole of
the base.
Important:
Remove plastic tip
cover on gas lift
before
assembling.
5
3
Plastic tip
4
3
4
5
3
Page 5
Assembly Instructions
Step 3
Attaching the seat
Position the seat as
shown and insert the gas
3
lift into the upper leg
2
. Secure by pressing
down the seat firmly.
2
Step 4
Gaslift operation
To adjust the seat higher,
lift up the lever under the
seat and release at
desired height.
To lower the seat, lift up
the lever while seated on
the stool.
3
Lever
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800
4
Loading...