Argos 514431 ASSEMBLY INSTRUCTIONS

Westminster Oak Console Table
Assembly Instructions - Please keep for future reference
424/3485
Dimensions
Width - 100cm Depth - 32cm Height - 75cm
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0845 6400800
issue 2 - 24/03/15
!
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
the following pages.
Remove all fittings from the plastic bags and separate them into their groups.
Keep children and animals away from the work area, small parts could choke if swallowed.
Make sure you have enough space to layout the parts before starting.
Care and maintenance
Only clean using a damp cloth and mild detergent, do not use
bleach or abrasive cleaners.
During assembly do not stand or put weight on the product, this could cause damage.
Assemble the item as close to its final position (in the same
room) as possible.
Assemble on a soft level surface to avoid damaging the unit or your floor.
Parts of the assembly will be easier with 2 people.
From time to time check that there are no loose screws on this unit.
To redure the likelihood of damaging your product please
ensure that your power drill is set on a low torque setting.
This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Handy Hints
Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts.
Regularly check and ensure that all bolts and fittings are tightened properly.
Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with
these instructions for future reference.
1
If you have damaged or missing components, call the
Components - Panels
Customer Helpline: Argos = 0845 6400800
Please check you have all the panels listed below
1 2
Top frame x 1 (100 x 32 cm)
Shelf frame x 1 (83 x 17.5cm)
3
Leg frame x 2 (71 x 29.5cm)
2
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
fittings may be supplied than are required.
A
M6x35mm Bolt x 8
Tools required
0
Ruler/tape
150140130120110100908070605040302010
measure
B
M6x55mm Bolt x 4
C
Allen key x 1
Ruler - Use this ruler to help correctly identify the screws
The screws length is measured from the head to the point (15 mm screw shown).
3
17016015014013012011010090807060504030201005 15 25 35 45 55 65 75 85 95 105 115 125 135 145 155 165
Assembly Instructions
Step 1
Removing the drawers.
Pull the drawer out until it is
fully extended. Turn the stopper to unlock. Pull the drawer out of the top frame
. Place the drawer aside.
1
Repeat with the other
drawer.
1
Step 2
Attaching the leg frames.
With the help of another
person, turn the top frame
over carefully.
1
Attach leg frames to the sides of the top frame using bolts .Tighten with allen key .
A
C
3
1
3
3
A
1
A
C
A
4
Assembly Instructions
Step 3
Securing the leg frames.
Attach the leg frames to the top frame using
B
bolts through the holes
1
3
shown. Tighten with allen
C
key .
B
B
C
1
B
B
Step 4
Attaching shelf frame.
Position the shelf frame between the side rails of leg
frames as shown. Fix through holes on shelf
frame using bolts .
With the help of another person, turn the table over carefully .
3
2
2
A
A
A
C
2
A
A
1
5
Assembly Instructions
Step 5
Inserting drawers.
Slide the drawer onto the runner .Turn the stopper
to lock.
Repeat with the other drawer.
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0845 6400800
6
Loading...