If you need help or have damaged or missing parts, call the
Customer Helpline: 03456 400800
Assembly Instructions - Please keep for future reference
Important - Please read these instructions fully before starting assembly
• To reduce the likelihood
of damaging your product
please ensure that your
power drill is set on a low
torque setting.
• Improper use of elecrical
tools will crack the
components.
• Dispose of all packaging
carefully and responsibly.
Important - Please read these instructions fully before starting assembly
• Check you have all
the components
and tools listed on
the following pages.
• Remove all
fittings from the
plastic bags and
separate them into
their groups.
• Keep children and
animals away from
the work area,
small parts could
choke if swallowed.
• Make sure you
have enough space
to layout the parts
before starting.
• During assembly do
not stand or put
weight on the
product, this could
cause demage.
• Assemble the item
as close to its final
position (in the same
room) as possible.
• Assemble on a soft
level surface to avoid
damaging the unit or
your floor.
• Parts of the
assembly will be
easier with 2 people.
•This product should not
be discarded with
household waste. Take to
your local authority waste
disposal centre.
• Assemble all parts
and bolts loosely
during assembly,
only once the
product is complete
should you fully
tighten the bolts.
• Regularly check and
ensure that all bolts
and fittings are
tightend properly.
Note : if requires the next page can
be cut out and used as reference
throughout the assembly. Keep this
page with these instructions for
future reference.
•Only clean using a
damp cloth and
mild detergent, do
no use bleach or
abrasive cleaners.
•From time to time
check that there are
no loose screws on
this unit.
Headboard x1
(164x120x6 cm)
Footboard x1
(164x77,5x6 cm)
Bed slats x15
(151,8x7x1,7
cm)
Bed side x2
(202x15x2 cm)
Middle Bar x1
(204x6x3 cm)
Middle foot x2
(20x6x3 cm)
Spacer block x2
(6,1x2,1x2,1 cm)
Flatblade
screwdriver
(medium)
Please check you have all the panels listed below
Phillips screwdriver
(medium & large)
Ruler - Use this ruler to help correctly identify the screws
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.