High Back Cube Chair
Please open all 3 boxes before commencing assembly of the set.
This box contains 2 chairs.
459/4598
3
3
For further assistance please visit http://www.argos-support.co.uk/
nuts
3
Issue 2: 05/
09
/15
Safety and Care Advice
Im portant - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2.
plastic bags and separate them
into their groups.
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Care and m ainte nance
Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
Do not stand or put weight on the
product during assembly, this could
cause damage.
Assemble the item as close
room) as possible.
Assemble on a soft level
surface to avoid damaging the
chair or your floor.
Parts of the assembly will be
easier with 2 people.
r
om time to time check that
F
the e are no loose nuts on
r
this chair.
We do not
recommend the
use of power
drill/drivers for
inserting screws ,
as this could damage the unit.
Only use hand screwdrivers.
Dispose of all packaging
carefully and responsibly.
Maximum safe seated
weight: 110kgs.
This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Make sure each studs
matches the corresponding
figure to ensure correct
assembly.
Assemble all parts and nuts
loosely during assembly,only
once the product is complete
should you fully tighten the
nuts.
1
3
For further assistance please visit http://www.argos
-support.co.uk/
1
5
The quantities beloware the correctamounttocomplete the assembly.In some cases more
fittings may be supplied than are required.
2
6
C
3
4
7
D
E
Stud x 9
M6x45
Tools required
Washer x 11
M6
1 x Allen key
Nut x 9
6X1.0
Screw x 2
Screw cap x 2
2
A s s e m b l y I n s t r u c t i o n s
C
Use stud ,washer ,
and
panel to back panel
by wrench.
C
nut to fix the seat
4
2
2
4
Right
Use stud ,washer ,
and
panel and right panel
to back panel by
wrench.
C
nut to fix the left
1
2
3
Do not fully tighten
nuts at this stage.
C
2
3
1
Do not fully tighten
nuts at this stage.
3
Assembly Instructions
Fit back to t he c hair
6
Use screw washer
to fix the back to the
D
6
chair, then cover the
screw with the screw
cap .
E
D
E
7
Tighten all the nuts
nuts,
place the cushion on
the chair
.
5
After all the parts are positioned, you can now fully
tighten all nuts fixed on previous steps.
For further assistance please visit http://www.argos-support.co.uk/
3
4
Loading...