Argos 457/3399 User guide

Page 1
BABY BY CHAD VALLEY DELUXE BOUNCER PINK
Assembly Instructions - IMPORTANT! Keep for future reference
457/3399
Dimensions
Width - 68cm Depth - 46.5cm Height - 55cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400 800
Page 2
Safety and Care Advice
IMPORTANT! – KEEP FOR FUTURE REFERENCE
This product should be assembled by an adult
WARNING: Never leave the child unattended in the reclined cradle. WARNING: Do not use the toy bar to lift or carry this bouncer. WARNING: It is dangerous to put this reclined cradle on an elevated surface. WARNING: The bouncer and toy bar must be assembled by an adult.
WARNING:This reclined cradle is not intended for prolonged periods of sleeping.This reclined cradle does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
Do not use the reclined cradle if any components are broken or missing.
Do not adjust the chair whilst your child is still in it.
Only use on a flat, level floor.
Do not use on a raised surface such as a table, kitchen work surface or bed.
Regularly check all fittings for security.
Do not use accessories or replacement parts other than those approved by the manufacturer.
Not recommended for children that can sit by themselves (6 months approximately; until 9kg)
Do not leave batteries in the vibration unit when the bouncer is not being used for long periods.
Always use the restraint system and ensure that the crotch strap and belt are correctly adjusted.
Do not use once the baby can sits unaided.
Never attempt to move the baby reclined cradle with a baby still seated inside.
Always use restraint system.
Keep away from fire a
This item complies with BS EN12790:2009.
The music box complies with the toys requirement and EN62115.
nd direct heat sources.
Battery
-The recommended battery sizes for this unit is 1.5V size AA.
-Do not mix new & used batteries.
-Do not mix batteries of different types.
-Only the recommended batteries or equivalent are to be used, volts and size.
-Batteries should be inserted with the correct polarity.
-Remove batteries when unit is stored for a long period of time or when the batteries are exhausted
-Dispose exhausted battery properly
-Do not short-circuit supply terminals.
-Do not attempt to recharge a non-rechargeable battery.
-Rechargeable batteries are to be removed from the toy before being charged.
-Rechargeable batteries are only to be charged under adult supervision.
WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL AUTHORITY FOR RECYCLING ADVICE.
Page 3
1.Parts List
If you have damaged or missing components, call the
Customer Helpline:
Please check you have all the parts listed below
03456 400 800
seat unit
toy bar
D
toys (X3)
E
screws 4.2X22mm (X2)
H
Music and Vibration
B
box(battery not included)
rear bar
F
I
left frame
C
right frame
G
screws 3.2X10mm (X2)
screws 4.2X16mm (X2)
J
Tools requirednot included
T
Phillips Screwdriver
Page 4
2. Battery Information
Switch off the power of the toy. Loosen the screw with a screwdriver to open the battery compartment door. Insert/replace 3 pcs 1.5v AA size battery in the proper direction indicated inside the battery compartment. Close and screw the battery door.
3. Assembly
1.5V AA
1.5V AA
1.5V AA
Step1
Put on the rear rubber feet to the rear bar, and insert left and right frame to the bar, then fix them with screws(I).
Step2
Put on the seat unit to the frames, and then fix with screws(H).
Page 5
Step3
Open the seat unit and press the seat until clicked. Please make sure the tube engage into the lock pin part as picture shows.
Step4
Insert music and Vibration Unit.
Step5
Switch the unit on: Use the left to select the
strength of the vibration and use the right to select the volume of the music.
NOTE: Please check batteries regularly. if the vibration and sound module does not function correctly, please replace the batteries with new or fully charged rechargeable batteries.
Page 6
Step6
There is an adjustable quick release buckle on either side of the combined crotch strap and waist pad. Place the baby into the bouncer with the pad between their legs, adjust stripe to fit your baby. Fasten the buckles on both sides of the restraint pressing until you hear a “click”.
Step7
Insert the 2 ends of toy bar into the slots on the hinges, the use the screwdriver to tighten the screw “J” as picture shows.
Page 7
Care and Maintenance
This product was designed and manufactured with quality materials and craftsmanship.
1. Inspect regularly for: Worn parts, torn materials or stitching.
Loose screws, bent or broken frame parts. Broken, damaged or missing parts.
Do not use the reclined cradle if any components are broken or missing.
2. Fabric parts and toys may be cleaned in accordance with the fabric and toys care labels. Do not machine wash. Hand wash only.
3. Do not store the product while wet and never store a damp environment as this can cause mildew to form.
Page 8
Argos Avebury, 489-499 Avebury Boulevard, Milton Keynes, MK9 2NW www.argos.co.uk Customer Helpline: 03456 400 800
Loading...