
Assembly Instructions
Close Table
Massey Oval Extendable Table
a:
Release safety locks
(see safety lock instruction
below) Hold the apron of
table to lift the table up and
pull the table tops out as
shown by the arrows.
b:
Close the extension
leaves.
a:
b:
Unfold apron of leaves
Assembly Instructions - Please keep for future reference
412/5156
c:
Hold the apron of table
to push on both sides of
tables as shown by the
arrows. Use safety locks
to ensure table tops will
not move while using.
(see safety lock instruction
below)
7
1
c:
Dimensions
Width - 115 (166)cm
Depth - 115cm
Height - 75cm
Important
SAFETY LOCK INSTRUCTION.
2
3
1 2
3
If you need help or have damaged or missing parts, call the
– Please read these instructions fully before starting assembly
Customer Helpline: 0345 640 0800
Issue 1 - 27/03/15
To release Safety lock
To secure Safety lock

Safety and Care Advice
Assembly Instructions
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
page 2 and 3.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Dispose of all packaging
carefully and responsibly.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Open Table
a:
Release safety locks
(see safety lock instruction
below) Hold the apron of
table to lift the table up and
pull the table tops out as
shown by the arrows.
b:
Make sure left and right
side top and extension
leaves are flat and aligned.
a:
Unfold apron of leaves
b:
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts.
• Reguraly check and ensure
that all bolts and fittings are
tightend properly.
c:
Hold the apron of table
to push on both sides of
tables as shown by the
arrows. Use safety locks
to ensure table tops will
not move while using.
(see safety lock instruction
below)
c:
SAFETY LOCK INSTRUCTION.
6
1
1
2
3
To release Safety lock
1 2
To secure Safety lock
3

Assembly Instructions
Components - Parts
If you have damaged or missing components,
call the
Customer Helpline: 0345 640 0800
Step 2
a:
Attach the legs
(x4) to each of the
corners, by first step
insert spring washers
and washers into all
the bolts . Then screw
the bolts through the
corner blocks and into the
holes in the legs .
Tighten bolts by using the
allen key .
Fully tighten all bolts.
C
A
A
D
2
B
2
a:
Please check you have all the parts listed below
C
B
A
2
Table top x 1
1
2
2
b:
2 people are required
for this next stage.
Turn the table upright and
place on desired location.
Assembly is complete.
b:
1
2
2
Leg x 4
If you need help or have damaged or missing parts, call the Customer Helpline: 0345 640 0800
5
2

Components -
Fittings
Assembly Instructions
Please check you have all the fittings listed below
Note :The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
A
Bolt x 8
D
Ball allenkey x 1
B
Spring washer x 8
C
Washer x 8
Step 1
Place table top upside
down being careful not to
scratch the table top
(lift the product within its
cardboard packaging will
assist you being able
to do this)
a:
To release the safety
locks.
a:
1
1
2
3
To pull the table tops
b:
out a little and provide the
space for installation of legs
as shown by arrows.
To release Safety lock
b:
3
4