Page 1
Ottawa Bar Stool
Assembly Instructions - Please keep for future reference
600/0444
600/5645
600/0468
397/6313
194803
194806
Dimensions
Width - 47cm
Depth - 45cm
Height - 78-100 cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800 Homebase = 0345 077 8888
Issue 4 - 31/03/15
Page 2
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Parts of the assembly will be
easier with 2 people.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• During assembly do not stand
or put weight on the product, this
could cause damage.
• Assemble the item as close to
its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Do not stand on the stool.
• Do not use this stool as a step
ladder.
• From time to time check that
there are no loose screws on
this unit.
• To reduce the
likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Unit weight: 6.3 kgs.
• Maximum safe weight of user:
110kgs.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the
bolts.
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
1
Page 3
If you have damaged or missing components, call the
Components - Parts
Customer Helpline: Argos = 0345 640 0800
Homebase = 0345 077 8888
Please check you have all the parts listed below
1
Seat
(41 x 47 x 23.5cm)
4
Decor ring
(Ø6.3 x 7.5 x 2.2cm)
2
Upper leg
(Ø5.8 x 39.5 x 16cm)
5
Base
(Ø38.5 x 8.5cm)
3
Gaslift
(Ø5 x 50-72cm)
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
A
M6 x 15mm Bolt x 4 Washer x 4
B
C
Allen key x 1
2
Page 4
Assembly Instructions
Step 1
Attaching upper leg
Place the seat upside
down on a flat protected
surface. Position the
upper leg and make
sure that the lever is at
your left hand side as
shown in the diagram.
Secure using washer
and bolt . Tighten bolts
A
using allen key .
1
2
B
C
Lever
A
2
2
A
A
B
B
1
A
A
B
B
1
B
Step 2
Step 3
Attaching gaslift
Place the base on a
5
flat protected surface.
Position the decor ring
4
on the base and
insert the gaslift into
3
the decor ring and hole
of the base.
Important:
Remove plastic tip
cover on
gaslift before
assembling.
Plastic tip
3
4
5
3
Page 5
Assembly Instructions
Step 3
Step 3
Attaching the seat
Position the seat as
shown and insert the
gaslift into the upper
leg . Secure by
pressing down the
seat firmly.
3
2
2
3
Gaslift operation
To adjust the seat higher,
lift up the lever under the
seat and release at
desired height.
To lower the seat, lift up
the lever while seated on
the stool.
Lever
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 640 0800 Homebase = 0345 077 8888
4
Loading...