Page 1
Amparo Table
Assembly Instructions - Please keep for future reference
600/1443
600/6527
600/6352
600/6541
144/7569
259/3807
621/5136
Dimensions
Width - 85cm
Length - 85cm
Height - 76cm
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Issue 4 - 7/09/16
Page 2
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fi ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its fi nal position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your fl oor.
• Parts of the assembly will be
easier with 2 people.
• From time to time check that
there are no loose screws on
this unit.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Handy Hints
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fi ttings are
tightend properly.
1
Page 3
If you have damaged or missing components, call the
Components - Panels
Customer Helpline: Argos = 0345 6400800
Please check you have all the panels listed below
1
Table leg x 4
(74 x 19cm)
Table top
2
(85 x 85cm)
Connecting plate x 4
3
(10 x 10cm)
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
17mm Bolt x 16
D
B
Nut x 8
C
Wrench x 1
Hex Key X 1
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
105
110 115 120 125 130 135 140 145 150 155 160 165 170
2
Page 4
Assembly Instructions
Step 1
Assemble table top
2
Place table top
upside down on a clean,
flat surface.
Fix connecting plate
onto the table top using
A
bolts
D
by using Hex key
Note: The direction of
the arrows should be
pointed outward as
shown in the figure.
3
A
A
A
A
3
3
3
3
2
Step 2
Assemble legs
1
Position leg
connecting board and
secure using nuts
using wrench
Note: Make sure the
direction of the table
legs is the same as
shown in the figure
during assembling.
Assembly is complete.
over the
B
by
C
.
B
B
1
1
1
1
2
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
Loading...